The Internet-of-Things (IoT) has gained significant importance in all aspects of daily life, and there are many areas of application for it. Despite the rate of expansion and the development of infrastructure, such systems also bring new concerns and challenges. Security and privacy are at the top of the list and must be carefully considered by designers and manufacturers. Not only do the devices need to be protected against software and network-based attacks, but proper attention must also be paid to recently emerging hardware-based attacks. However, low-cost unit software developers are not always sufficiently aware of existing vulnerabilities due to these kinds of attacks. To tackle the issue, various platforms are proposed to enable rapid and easy evaluation against physical attacks. Fault attacks are the noticeable type of physical attacks, in which the normal and secure behavior of the targeted devices is liable to be jeopardized. Indeed, such attacks can cause serious malfunctions in the underlying applications. Various studies have been conducted in other research works related to the different aspects of fault injection. Two of the primary means of fault attacks are clock and voltage fault injection. These attacks can be performed with a moderate level of knowledge, utilizing low-cost facilities to target IoT systems. In this paper, we explore the main parameters of the clock and voltage fault generators. This can help hardware security specialists to develop an open-source platform and to evaluate their design against such attacks. The principal concepts of both methods are studied for this purpose. Thereafter, we conclude our paper with the need for such an evaluation platform in the design and production cycle of embedded systems and IoT devices.
30 April 2021 in IEEE Consumer Electronics Magazine
Sorting is an inseparable part of applications that process massive amounts of data. A hardware-designed sorter increases the performance at the cost of increasing the required resources, the issue that is limited in the FPGA chips. This paper proposes a new Ultra-Low-Power 3-dimensional hardware sorting architecture, the so-called ULPSorter, based on the Multi-Dimensional Sorting Algorithm (MDSA). The hardware resources and power consumption are significantly decreased in the ULPSorter architecture in comparison with previous state-of-the-art techniques. The simulation results show that ULP-Sorter reduces the number of Look-Up Tables (LUT) and registers by 70% and 35.7%, respectively, in comparison to previous state-of-the-art techniques. ULP-Sorter reduces the FPGA's power consumption on average by 48.7% in comparison with previous state-of-the-art techniques. The results indicate that ULP-Sorter is a suitable architecture for edge computing devices with limited power and area constraints.
Embedded systems are vulnerable to significant security threats from Fault Injection Attacks (FIAs), which allow attackers to gain access to confidential information. While various attack detectors have been proposed in the literature to detect different types of FIAs, these detectors themselves are susceptible to such attacks and can be compromised. Hence, the robustness of these detectors is critical in maintaining the security of embedded systems. The focus of this study is to evaluate the robustness of digital circuits and delay-based digital detectors against a new type of FIA called Power-Off Attack (POA). POA occurs when the power to the chip is turned off, and the detectors are not active. Following a POA attack, the circuit or its detectors may not function properly when the power is turned back on, which can allow other attacks to be applied without being detected if the detectors are less sensitive. This study implements two detectors on Xilinx Artix-7 FPGAs and examines the impact of heating cycles on detector characteristics when the FPGA is in various states, including power-off, power-on, and inactive states (such as clock-freezing mode). Our experiments reveal that heating cycles in power-off mode can alter the FPGA component delays and the accuracy of its detectors, which highlights the vulnerability of these systems to POA and potential issues for embedded system security.
Attaques par injection de fautes sur les applications embarquées : caractérisation et évaluation: L’évaluation de la sécurité des appareils IoT contre les menaces logicielles et matérielles potentielles est désormais une tâche nécessaire pour les développeurs de logiciels embarqués. Avoir un accés physique aux appareils cibles fait de la sécurité du matériel une préoccupation importante à prendre en compte dans les IoT. Parmi les techniques d’attaque de sécurité matérielle, les attaques par injection de fautes telles que les problémes d’horloge sont l’une des attaques les plus pratiques, non invasives et peu coûteuses. Ils peuvent interférer avec les opérations attendues et provoquerde graves dysfonctionnements dans l’appareil ciblé. À cet égard, un cadre d’évaluation de la sécurité efficace et une méthodologie contre les attaques par injection de fautes sont nécessaires pour évaluer correctement les dispositifs embarqués.Il est souvent difficile pour le développeur de logiciels d’utiliser correctement une plate-forme d’injection de fautes. Par conséquent, cette thése s’est concentrée sur la conception d’une plateforme facile à utiliser dédiée aux attaques par défaut d’horloge afin d’évaluer les vulnérabilités des applications logicielles embarquées. Ce travail propose une plateforme d’évaluation open source suivie de méthodologies d’évaluation de haut niveau. Ensuite, un processus de caractérisation basé sur une approche de simulation préliminaire est présenté pour améliorer les paramétres expérimentaux d’injection de fautes. Enfin, les impacts des failles injectées sont analysés et étudiésdans une application médicale open source (Sec-Pump) en tant qu’étude de cas dans le cadre du projet SERENE-IoT. Le projet SERENE IoT (Secured & EneRgy EfficieNt health-care solutions for IoT market) vise à développer des dispositifs IoT intelligents de haute qualité pour l'e-santé en Europe. Le projet SERENE-IoT est labellisé dans le cadre de PENTA, le cluster EUREKA pour la recherche applicative et technologique en Europe sur la nanoélectronique. La plateforme et la méthodologie proposées dans cette thése peuvent identifier avec succés les vulnérabilités de sécurité dans une application embarquée et guider le développeur de logiciels pour atténuer de telles attaques.Motsclel's— Sécurité matérielle, Systémes Embarqués, Attaques par Injection de Fautes, Glitch d’horloge