An ultra-low quiescent current resistor-less power on reset circuit is presented in this paper. The circuit is used in energy harvesting systems to change boost converter from startup state to PWM modulation state. It integrates power on reset (POR) and brown out detection (BOD) functions without resistors or bandgaps overhead. Dual threshold detection (DTD) technology is used instead of a large size delay cell in generation of pulse signals. The circuit has been implemented in a 0.13μm standard CMOS technology. The active area and the quiescent current of the circuit are 154.4μm × 26.8μm and about 1nA, respectively. Ultra-low quiescent current and small area make the proposed circuit suitable to be applied in low power applications like energy harvesting and beyond.

Multilevel storage and the continuing scaling down of technology have significantly improved the storage density of phase change memory, but have also brought about a challenge, in that data reliability can degrade due to the resistance drift. To ensure data reliability, many read and write operation technologies have been proposed. However, they only mitigate the influence on data through read and write operations after resistance drift occurs. In this paper, we consider the working principle of multilevel storage for PCM and present a novel 2T2R structure circuit to increase the storage density and reduce the influence of resistance drift fundamentally. To realize 3-bit per cell storage, a wide range of resistances were selected as different states of phase change memory. Then, we proposed a 4:3 compressing encoding scheme to transform the output data into binary data states. Therefore, the designed 2T2R was proven to have optimized storage density and data reliability by monitoring the conductance distribution at four time points (1 ms, 1 s, 6 h, 12 h) in 4000 devices. Simulation results showed that the resistance drift of our proposed 2T2R structure can significantly improve the storage density of multilevel storage and increase the data reliability of phase change memory.

The thermoelectric generator (TEG) stands out among many energy harvesters due to its simple structure, small size, rich thermal energy, and the absence of pollution and noise. However, previous studies have rarely probed into the influence of TEG internal resistances on extracting maximum power from TEGs, and the tracking of efficiency is limited. By analyzing the relationship between the tracking efficiency and the TEG internal resistances, a time exponential rate perturbation and observation (P&O) technology is proposed to achieve maximum power point tracking (MPPT) for a wide resistance range of the TEG. Using the time exponential rate P&O, the MPPT circuit observed the power change by comparing the positive-channel metal-oxide semiconductor (PMOS) on-time and perturbs the power by adjusting the negative-channel metal-oxide semiconductor (NMOS) on-time exponentially. The MPPT circuit was implemented in a 110 nm complementary metal-oxide semiconductor (CMOS) process. The tracking efficiency maintained a high level from 98.9 to 99.5%. The applicable range of the TEG resistance was from 1 to 12 Ω, which reflects an enhancement of at least 2.2 times.