The necessity of having windows on any building’s façade is not questionable. However, not every window is suitable for any building. The selection of an adequate window must include the analysis of various factors—the most important ones are the type of window (e.g., single or double glazing); filling gas in cavities (e.g., air, argon or some other gas); and placing, i.e., orientation of a window on a façade (facing north, south, or east, etc.). The research presented in this paper is dealing with the calculation of the window thermal loading for the cities of Kragujevac and Bor in Serbia and Žilina in Slovakia. These three cities were selected because they belong to different climate regions, according to the Köppen–Geiger climatic classification. The first two cities in Serbia belong to the same region Cf with difference only in the category of summer—Kragujevac Cfa and Bor Cfb—while the third city—Žilina in Slovakia—belongs to the Dfb region. The calculated thermal loading through the window was obtained as a sum of the thermal loading due to the heat conduction and thermal loading due to the solar radiation. The objective was to find the optimal window construction and orientation of a building’s façade for each of these cities, by varying the type of the window, its frame material and the filling gas. The results show that for the first two cities in Serbia, there is a difference in the window frame material in the optimal window construction, while for the third city (Žilina in Slovakia), the results are the same as for the second city (Bor in Serbia) despite the fact that they belong to different climate regions (Cfb and Dfb, respectively). These results support the fact that the climate affects the optimal window construction for any city/region in the world.
Reactive powder concrete (RPC), typically with higher compressive strength, is particularly attractive to structural engineers to apply them in infrastructures for enhancing their resistance under severe environments and loads. The main objective of the initial study presented in the paper was to investigate the behavior of two types of these new cementitious materials differing in the nature of microfibers. The RPC mixes were reinforced with steel and then with basalt microfibers. To evaluate the structural performance of developed unconventional materials, properties were investigated experimentally and compared with the control normal concrete mix. Mechanical tests indicated that dispersing fine fibers for making RPC, a mean compressive strength of 198.3 MPa and flexural strength 52.6 MPa or 23.2 MPa, respectively, were developed after 28 days of standard curing at ambient temperatures. In composite structures consisting of steel girders and a concrete slab, it is necessary to prevent the relative slip at the steel and concrete interface using shear connectors. The very high RPC strength enabled a material saving, weight-reduced application of precast construction, and particularly effective joint to steel beams. The investigation of such shear connection efficiency, in the case of the higher strength concrete deck, using standard push-out test specimens was executed. Finite element numerical models were developed. The outputs of the studies are presented in the paper.