Stefan Skoog

Dr. Stefan Skoog


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 April 2020 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
AAAlessandro Acquaviva
Alessandro Acquaviva
SSStefan Skoog
Stefan Skoog
TTTorbjörn Thiringer
Torbjörn Thiringer
Tooth coil windings, in particular when using a double layer structure, present opportunities for in-slot liquid cooling. Since the windings are not overlapping, access to the slot from the end section for coolant liquids is enabled. In this paper, a solution for in-slot and in-stator direct oil cooling for a tooth coil winding machine is presented. The coils are pre-wound on bobbins and inserted on the stator teeth. The novelty of the design consists in the integration of the cooling, using a thermally conductive epoxy resin to create the channels within the slot as well as the positioning of the stator yoke cooling channels. A 50 kW machine for an automotive traction ap-plication is designed, manufactured and tested. Conjugate heat transfer simulations are used in the design process in combination with finite element analysis for the loss mapping. The thermal model is verified with measurements at 6 l/min oil flow and 17.5 A/mm $^{2}$ continuous and 35 A/mm $^{2}$ 30 s peak. The thermal model is then used to establish a continuous operating point of 25 A/mm $^{2}$ .

30 June 2020 in Energies
Verified
Journal Article
Open access
PDF file
AAAlessandro Acquaviva
Alessandro Acquaviva
SSStefan Skoog
Stefan Skoog
EGEmma Grunditz
Emma Grunditz
TTTorbjörn Thiringer
Torbjörn Thiringer
Tooth coil winding machines offer a low cost manufacturing process, high efficiency and high power density, making these attractive for traction applications. Using direct oil cooling in combination with tooth coil windings is an effective way of reaching higher power densities compared to an external cooling jacket. In this paper, the validation of the electromagnetic design for an automotive 600 V, 50 kW tooth coil winding traction machine is presented. The design process is a combination of an analytical sizing process and FEA optimization. It is shown that removing iron in the stator yoke for cooling channels does not affect electromagnetic performance significantly. In a previous publication, the machine is shown to be thermally capable of 25 A/mm 2 (105 Nm) continuously, and 35 A/mm 2 (140 Nm) during a 10 s peak with 6 l/min oil cooling. In this paper, inductance, torque and back EMF are measured and compared with FEA results showing very good agreement with the numerical design. Furthermore, the efficiency of the machine is validated by direct loss measurements, using a custom built calorimetric set-up in six operating points with an agreement within 0.9 units of percent between FEA and measured results.