We proposed a folded line spoof surface plasmonic polaritons (SSPPs) waveguide that allows for efficient and strongly constrained microwave SSPPs transmission. The dispersion characteristics of SSPPs waveguides based on folded line unit is investigated. Compared to conventional rectangular-grooved SSPPs waveguide with the same cut-off frequency, the lateral dimension of the folded line SSPPs waveguide can be reduced to 56%. The results show that the folded line SSPPs waveguide has stronger field binding as well as better miniaturization advantages. In order to validate the proposed design, a dual-band band-pass filter is designed based on the high-order mode of the proposed unit and we then add an asymmetric structure to achieve a tri-band band-pass filter with good performance. In addition, a band-pass filter with wide stopband between two pass bands is designed by incorporating an interdigital finger in the folded line unit, whose width of the stopband can be increased by 50% compared to the filter without interdigital finger. By optimizing the length of interdigital finger, two notch bands are respectively obtained in two pass bands of a dual-band pass-band filter. At the same time, the stopband is also widened. Four proposed filters are fabricated and the measurement results are in good agreement with the simulated ones, verifying the feasibility of the structure. The proposed SSPPs structure can significantly enhance the flexibility and universality of the filter. Additionally, these filters offer compact structures, wide stopbands, and hold immense potential for application in integrated devices.
10 June 2025 in IEEE Microwave and Wireless Technology Letters
We propose a novel F-fold spoof surface plasmon polaritons (SSPPs) unit with independently tunable high-order rejection bands. The dispersion characteristics of the proposed F-fold SSPPs are analyzed. The results show that the cutoff frequencies of Modes 2 and 3 can be precisely adjusted through structural parameters, enabling independent control of the stopband position formed by these two modes, without affecting the fundamental mode (Mode 0) or Mode 1. Therefore, the passband number, bandwidth, and stopband width can be flexibly manipulated for the design of multiple passband filters. For verification, a tri-passband, quad-passband filter, and wide stopband filter are designed, fabricated, and measured. The wide stopband filter achieves a 547% increase in the stopband width compared to the tri-passband filter. Good agreement between the simulations and measurements confirms the feasibility of the proposed structure and design method.
10 November 2015 in International Journal of Antennas and Propagation
A waveguide 10 dB directional coupler operating from 325 GHz to 400 GHz is designed based on the short-slot Riblet-type coupling configuration and fabricated using the deep reactive ion etching (DRIE) silicon micromachining technique. The skin depth and the conductivity of the gold film with the roughness of 0.2 μm are investigated at 300~1000 GHz frequency band for the higher accuracy. In order to measure the small-size four-port coupler using the two-port VNA with big-size flanges, three testing topologies are designed, in which the terahertz (THz) wedged-type absorbing material terminals are adopted as the waveguide matching loads. The measured average insertion loss is 0.5 dB after deducting the intrinsic loss and the measured average isolation is better than 25 dB, which are in good agreement with simulations. The analysis and the design are verified to be accurate and valuable for the high-performance sub-millimeter-wave waveguide components.
Previous studies have shown that the nano-crystallization process has an appreciable impact on the luminescence properties of nanocrystals, which determines their defect state composition, size and morphology. This project aims to explore the influence of nanocrystal size on the electrical and optical properties of Cr2+:ZnSe nanowires. A first-principles study of Cr2+:ZnSe nanowires with different sizes was carried out at 0 K in the density functional framework. The Cr2+ ion was found to prefer to reside at the surface of ZnSe nanowires. As the size of the nanocrystals decreased, a considerable short-wave-length shift in the absorption of the vis-near infrared wavelength was observed. A quantum mechanism for the wavelength tunability was discussed.