The layout of a low-permittivity material is designed in a power semiconductor module to reduce parasitic common mode (CM) capacitance and hence attenuate the CM current. Without sacrificing the thermal performance between the semiconductor devices and heat sink, a portion of the bottom copper of a direct-bond-copper substrate is replaced by air to decrease capacitance. The proposed power module is verified in a 1-kW 100-kHz buck converter. The CM current is decreased by 8 dB in the frequency domain without any additional components or filters.
17 August 2020 in IEEE Transactions on Power Electronics
An auxiliary current control is proposed herein to improve the load transient response of the buck converter. The proposed technique increases the efficiency of the auxiliary converter by employing soft switching. The design guidelines for achieving a capacitor charge balance for the output capacitor during the transition are also presented. The simulation results revealed that the output voltage overshoot and settling time during the load step-down transient were 62 mV and 29.4 μs, respectively; however, in the case of conventional time-optimal control, these values were 666 mV and 57.2 μs, respectively, under the same condition. The estimated power loss of the proposed scheme was only 45%-60% of those of the conventional counterparts. The performance and effectiveness of the technique were experimentally verified using a prototype buck converter with a 15 V input, 3.3 V output, and 200 kHz switching frequency.
6 August 2024 in IEEE Transactions on Power Electronics
This article proposes a novel power module configuration which replaces a part of the bottom copper layer of a direct-bonded copper by low-permittivity (low- ϵ ) epoxy. The proposed power module reduced common-mode (CM) capacitance by 52.5% compared to that of the conventional counterpart. The CM noise measured from line impedance stabilization network was reduced by 4–5 dB μ V in steady-state operation. The proposed power module does not sacrifice thermal performance which is proved by simulation and thermal resistance measurement. Thermal cycling tests confirmed high mechanical reliability with no cracks in the solder near the epoxy region. Less mechanical deformation of 5.80 μm was observed compared to the 9.48 μm of the power module that adopts air instead of low- ϵ epoxy.
8 June 2021 in IEEE Transactions on Power Electronics
An in-depth analysis on the load transient operation of a buck converter with auxiliary current control is presented in this article. The analysis quantifies the effects of nonideal characteristics, such as the equivalent series resistance, inductor current and output voltage ripples, time delay, and slew rate of the load current, on the fluctuation of the output voltage in a practical implementation. The analysis results reveals that some of the non-idealities may cancel each other out and become negligible in the implementation. A design considering the nonidealities can achieve the transient-wise capacitor charge balance of the output capacitor and minimize the output voltage deviation during the load transient. The agreement between the simulation and experimental results validates the effectiveness and precision of the proposed analysis and design.
17 August 2022 in IEEE Transactions on Industrial Electronics
This article proposes a novel voltage-controlled variable inductor (VI) for fixing the switching frequency of dc–dc converters in the critical conduction mode (CRM). It overcomes the limitations of conventional current-controlled VIs such as complex winding structures, difficulties in control, and high sensitivity to temperature. In the proposed voltage-controlled VI, the primary side inductance of a coupled inductor is regulated by an auxiliary voltage source on the secondary side. The auxiliary voltage source is implemented by an auxiliary dc–dc converter, which delivers power to the load in parallel with the main converter. The operating principle of the converter system for employing the proposed VI is presented, and a control loop is designed to fix the switching frequency, considering the small-signal model of the auxiliary converter. The validity of the proposed VI is experimentally verified using a prototype CRM boost converter with an output voltage of 400 V and a maximum power of 400 W. The switching frequency is fixed at 100 kHz and the soft switching of the main converter is maintained regardless of the input voltage and output power.
5 December 2018 in Journal of Thermal Science and Engineering Applications