Purpose: The secondary phase decreased the corrosion resistance because of the segregation of Cr and Mo. Therefore, this paper aims to study the precipitation condition and the effect of secondary phase with volume fraction on corrosion behavior. Design/methodology/approach: Secondary phase precipitated approximately from 375°C to 975°C because of saturated Cr and Mo at grain boundary by growth of austenite. Therefore, heat treatment from 800°C to 1,300°C was applied to start the precipitation of the secondary phase. Findings: The secondary phase is precipitated at 1,020°C because of segregation by heterogeneous austenite. The growth of austenite at 1,000°C needs the time to saturate the Cr and Mo at grain boundary. When the volume fraction of austenite is 56 per cent (14 min at 1,000°C), the secondary phase is precipitated with grain boundary of austenite. The secondary phase increased the current density (corrosion rate) and decreased the passivation. That is checked to the critical pitting temperature (CPT) curves. The 1 per cent volume fraction of secondary phase decreased CPT to 60°C from 71°C. Research limitations/implications: The precipitation of secondary phase not wants anyone. Casted super-duplex stainless steel (SDSS) of big size precipitates the secondary phase. This study worked the precipitation condition and the suppression conditions of secondary phase. Social implications: Manufacturers need precipitation condition to make high-performance SDSS. Originality/value: The corrosion resistance of SDSS is hard the optimization because SDSS is dual-phase stainless steel. The precipitation of the secondary phase must be controlled to optimize of the corrosion resistance of SDSS. Anyone not studied the precipitation condition of secondary phase and the effect of secondary phase with volume fraction on corrosion behavior of SDSS.

With increasing demand for Li-ion batteries, studies are focusing on enhancing battery performance and safety. However, studies on battery cases remain scarce. Herein, we propose the use of super duplex stainless steel SAF2507, which is a two-phase (austenite + ferrite) steel, for battery casings. Unlike conventional AISI304, SAF2507 maintains its corrosion resistance and strength at high temperatures and precipitates a secondary phase at approximately 975 °C. However, the effects of Ni plating on this secondary phase are not well documented. Therefore, the electroless Ni plating of SAF2507 after secondary-phase precipitation was studied. Briefly, heat treatment at 1000 °C was used to induce precipitation, and the electroless Ni plating behaviour over varying plating periods was analysed using open-circuit potential, potentiodynamic polarisation, and electrochemical impedance spectroscopy measurements. The plating state and corrosion behaviour were examined using scanning electron microscopy. Heat-treated SAF2507 steel with a secondary phase exhibited excellent electroless Ni plating behaviour, which enhances the safety and durability of Li-ion batteries. Furthermore, uniform plating and electrochemical behaviour were achieved after 180 s, suggesting that SAF2507 is superior to AISI304. These findings contribute to the development of safer and more efficient batteries and address the growing demand for Li-ion battery case materials.

Super duplex stainless steel (SDSS) is used for manufacturing large valves and pipes in offshore plants because of its excellent strength and corrosion resistance. Large valves and pipes are manufactured by forging after casting, and the outside and inside microstructures are different owing to the difference in the cooling rate caused by the thermal conductivity. This microstructural variation causes cracks during solution annealing, which breaks the materials. To study the corrosion resistance of the SDSS forged material, the influence of the microstructure according to the difference between the inside and outside cooling rates of the cast SDSS was evaluated. To analyze the effects of the secondary phase fraction before solution annealing on the solution and corrosion resistance, the corrosion resistance with and without solution annealing was measured using the potentiodynamic polarization test and critical temperature test after the precipitation of the secondary phase. In the potentiodynamic polarization test, the secondary phase decreased the activation polarization and increased the corrosion rate. The critical pitting temperature exhibited the effect of the secondary phase.