Precipitation of metals as metal sulphides is a practical way to recover metals from mine water. Sulphide precipitation is useful since many metals are very sparingly soluble as sulphides. Precipitation is also pH dependent. This article investigates the precipitation of metals individually as sulphides and assesses which metals are precipitated as metal hydroxides by adjustment of the pH. The precipitation of different metals as sulphides was studied to determine the conditions under which the HS⁻ solution from the sulphate reduction reaction could be used for precipitation. H₂S gas and ionic HS⁻ produced during anaerobic treatment could be recycled from the process to precipitate metals in acidic mine drainage (AMD) prior to anaerobic treatment (Biological sulphate reduction), thereby recovering several metals. Precipitation of metals with HS⁻ was fast and produced fine precipitates. The pH of acid mine water is about 2–4, and it can be adjusted to pH 5.5 before sulphide precipitation, while the precipitation, on the other hand, requires a sulphide solution with pH at 8 and the sulphide in HS⁻ form. This prevents H₂S formation and mitigates the risk posed from the evaporation of toxic hydrogen sulphur gas. This is a lower increase than is required for hydroxide precipitation, in which pH is typically raised to approximately nine. After precipitation, metal concentrations ranged from 1 to 30 μg/L.

Phosphorus as phosphate and nitrogen as ammonium or nitrate are the main nutrients in wastewaters and agricultural sludges. They runoff easily to waterways and cause eutrophication in water bodies. However, ammonium and phosphate could be precipitated simultaneously and used as recycled nutrients. In this research, dolomite calcined at 650 °C, 750 °C, or 950 °C and commercial MgO were used as precipitants in simultaneous phosphate and ammonium removal from synthetic (NH₄)₂HPO₄ solution and agricultural sludge. Calcination at 750 °C was the preferred option as dolomite was decomposed to MgO and CaCO₃ for optimal struvite precipitation. Molar ratios of 1.1–1.6:1–2:2 (Mg:P:N) were employed in the experiments. Very robust ammonium removal was obtained with MgO (57%), dolomite 650 °C and dolomite 750 °C (75%). MgO removed almost all phosphate, while dolomite 650 °C removed 65%, and dolomite 750 °C removed 60% (70% from agricultural sludge). Some part of the phosphate was adsorbed, most likely by CaCO₃, during dolomite precipitation. Struvite was the only identified reaction product in all samples after 24 h of precipitation. Calcined dolomite had great potential in ammonium and phosphate precipitation from both synthetic waters and agricultural sludges and the precipitates could be used as recycled fertilizers.

Industrial wastewaters may contain toxic or highly inhibitive compounds, which makes the measurement of biological oxygen demand (BOD) challenging. Due to the high concentration of organic compounds within them, industrial wastewater samples must be diluted to perform BOD measurements. This study focused on determining the reliability of wastewater BOD measurement using two different types of industrial wastewater, namely pharmaceutical wastewater containing a total organic carbon (TOC) value of 34,000 mg(C)/L and industrial paper manufacturing wastewater containing a corresponding TOC value of 30 mg(C)/L. Both manometric respirometry and the closed-bottle method were used in the study, and the results were compared. It was found that the dilution wastewaters containing inhibitive compounds affected BOD values, which increased due to the decreased inhibiting effect of wastewater pollutants. Therefore, the correct BOD for effluents should be measured from undiluted samples, while the diluted value is appropriate for determining the maximum value for biodegradable organic material in the effluent. The accuracy of the results from the blank samples was also examined, and it was found that the readings of these were different to those from the samples. Therefore, the blank value that must be subtracted may differ depending on the sample.