This work deals with the substantially high-temperature hydrogen sensors required by combustion and processing technologies. It reports the synthesis of undoped and Ni-doped TiO2 (with 0, 0.5, 1 and 2 mol.% of Ni) nanoparticles by a co-precipitation method and the obtained characteristics applicable for this purpose. The effect of nickel doping on the morphological variation, as well as on the phase transition from anatase to rutile, of TiO2 was investigated by scanning electron microscopy, X-ray diffraction and Raman spectroscopy. The resistive sensors prepared with these powders were tested toward H2 at 600 °C. The results indicate that 0.5% Ni-doped TiO2 with almost equal amounts of anatase and rutile shows the best H2 sensor response (ΔR/R0 = 72%), response rate and selectivity. The significant improvement of the sensing performance of 0.5% Ni-doped TiO2 is mainly attributed to the formation of the highest number of n-n junctions present between anatase and rutile, which influence the quantity of adsorbed oxygen (i.e., the active reaction site) on the surface and the conductivity of the material.
High-temperature gas sensing requires the increase of sensitivity and reduction of cross-sensitivity. The use of TiO2-Nanotubular layers as gas sensors has shown that the selectivity and sensitivity can be influenced by doping with trivalent elements and by optimization of morphological aspects such as pore diameter and nanotube length. In this work, focus has been given on the understanding of the effect of doping and properties of nano-tubular TiO2-layers on sensing behavior and mechanism toward NO2 by using equivalent circuit modeling achieved by impedance spectroscopic measurements.
1 November 2016 in Sensors and Actuators B: Chemical
Sea urchin spines of Holopneustes porossisimus are porous single crystals, with the pores being filled with a material rich in carbon, silicon, fluorine and sodium. The magnesian calcite constituting the spine is highly strained. Even though the spines appear to be single crystalline on a macroscopic scale, the calcitic material exhibits an extended defect network. We find dislocations as well as rotational and other, not yet identified boundaries. We also observe within spine calcite a patterned distribution of sulphur. Both distributions, that of the defect network and that of sulphur resemble in their pattern to each other and have a similar mesh size of 50 nm. We conclude from these observations that they arise from the growth process of the spine and account for the mosaicity within the spine single crystals.