Roussin LONTIO FOMEKONG

Dr. Roussin LONTIO FOMEKONG

Higher Teacher Training College of the University of Yaounde 1
orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 April 2021 in Frontiers in Sensors
Verified
Journal Article
Open access
PDF file
Bilge Saruhan-BringsBilge Saruhan-Brings
Bilge Saruhan-Brings
Roussin LONTIO FOMEKONGRoussin LONTIO FOMEKONG
Roussin LONTIO FOMEKONG
SNSvitlana Nahirniak
Svitlana Nahirniak
Semiconductor metal oxides (SMOxs) are widely used in gas sensors due to their excellent sensing properties, abundance, and ease of manufacture. The best examples of these sensing materials are SnO2 and TiO2 that have wide band gap and offer unique set of functional properties; the most important of which are electrical conductivity and high surface reactivity. There has been a constant development of SMOx sensor materials in the literature that has been accompanied by the improvement of their gas-sensitive properties for the gas detection. This review is dedicated to compiling of these efforts in order to mark the achievements in this area. The main material-specific aspects that strongly affect the gas sensing properties and can be controlled by the synthesis method are morphology/nanostructuring and dopants to vary crystallographic structure of MOx sensing material.

1 December 2020 in Applied Surface Science
Verified
Journal Article
Closed access
ZWZhe Wang
Zhe Wang
AHAzhar Ali Haidry
Azhar Ali Haidry
LXLijuan Xie
Lijuan Xie
AZAli Zavabeti
Ali Zavabeti
ZLZhong Li
Zhong Li
BSBilge Saruhan
Bilge Saruhan

1 January 2018 in Journal of Alloys and Compounds
Verified
Journal Article
Closed access
Roussin LONTIO FOMEKONGRoussin LONTIO FOMEKONG
Roussin LONTIO FOMEKONG
HKH.M. Tedjieukeng Kamta
H.M. Tedjieukeng Kamta
JLJ. Ngolui Lambi
J. Ngolui Lambi
DLD. Lahem
D. Lahem
PEP. Eloy
P. Eloy
ADA. Delcorte
A. Delcorte

16 November 2018 in RSC Advances
Verified
Journal Article
Open access
PDF file
HTHypolite Mathias Kamta Tedjieukeng
Hypolite Mathias Kamta Tedjieukeng
PTPatrice Kenfack Tsobnang
Patrice Kenfack Tsobnang
Roussin LONTIO FOMEKONGRoussin LONTIO FOMEKONG
Roussin LONTIO FOMEKONG
EEEkane Peter Etape
Ekane Peter Etape
PJPattayil A. Joy
Pattayil A. Joy
JLJohn Ngolui Lambi
John Ngolui Lambi
Low level copper-doped CoFe 2 O 4 has been synthesized and shows an increasing of saturation magnetization up to 6% Cu, subsequently decreasing above 6%.

19 September 2022 in Heliyon
Verified
Journal Article
Open access
HAHippolyte Todou Assaouka
Hippolyte Todou Assaouka
DDDaniel Manhouli Daawe
Daniel Manhouli Daawe
Roussin LONTIO FOMEKONGRoussin LONTIO FOMEKONG
Roussin LONTIO FOMEKONG
INIssah Njiawouo Nsangou
Issah Njiawouo Nsangou
PKPatrick Mountapmbeme Mountapmbeme Kouotou
Patrick Mountapmbeme Mountapmbeme Kouotou
Herein CuO nanoparticles (NPs) with nanostructures were prepared by precipitation method using hydrate copper sulfate (CuSO4.5H2O) and sodium hydroxide followed by heat treatment at 400 °C. The as-prepared CuO NPs with nanostructures were investigated using X-ray diffraction (XRD), Fourier Transformed Infra-red spectroscopy (FTIR), Raman spectroscopy, Scanning electron microscopy (SEM), X-ray photochemical spectroscopy (XPS), Energy dispersive spectroscopy (EDS), and Ultra-violet-visible (UV-vis) spectroscopy. In order to evaluate the reducibility, temperature programmed reduction (H2-TPR) was applied. More importantly, CuO NPs was successfully tested as catalyst towards the total conversion of carbon monoxide (CO) and toluene (C7H8). Both XRD and Raman analysis as well as FTIR show that the sample exhibited a monoclinic spinel structure. SEM images indicate that CuO NPs are well-covered by grains size exhibiting homogeneous morphology composed of very fine interconnected particles with an apparent porosity. The sample was made up of Cu and O, according to the XPS and EDS measurements. The band gap energy obtained from optical property analysis is ∼2.65 eV. The catalytic performances of CuO NPs can be assigned to the combined effects of crystal structure, morphology, surface oxygen mobility, redox property and the higher specific surface area (∼87 m2/g). More precisely XPS and H2-TPR data suggests that, the conversion of CO and C7H8 over CuO NPs follows a Mars-van Krevelen type mechanism. More importantly CuO NPs catalysts is reusable and exhibited good stability in the prolonged isothermal test. Thus, CuO NPs is confirmed as an efficient and inexpensive catalysts for CO and C7H8 conversion at low temperatures.

22 October 2020 in Sensors
Verified
Journal Article
Open access
PDF file
Roussin LONTIO FOMEKONGRoussin LONTIO FOMEKONG
Roussin LONTIO FOMEKONG
KKKelm Klemens
Kelm Klemens
Bilge Saruhan-BringsBilge Saruhan-Brings
Bilge Saruhan-Brings
This work deals with the substantially high-temperature hydrogen sensors required by combustion and processing technologies. It reports the synthesis of undoped and Ni-doped TiO2 (with 0, 0.5, 1 and 2 mol.% of Ni) nanoparticles by a co-precipitation method and the obtained characteristics applicable for this purpose. The effect of nickel doping on the morphological variation, as well as on the phase transition from anatase to rutile, of TiO2 was investigated by scanning electron microscopy, X-ray diffraction and Raman spectroscopy. The resistive sensors prepared with these powders were tested toward H2 at 600 °C. The results indicate that 0.5% Ni-doped TiO2 with almost equal amounts of anatase and rutile shows the best H2 sensor response (ΔR/R0 = 72%), response rate and selectivity. The significant improvement of the sensing performance of 0.5% Ni-doped TiO2 is mainly attributed to the formation of the highest number of n-n junctions present between anatase and rutile, which influence the quantity of adsorbed oxygen (i.e., the active reaction site) on the surface and the conductivity of the material.