The paper demonstrates that the dry clutch friction plate wear rate, measured based on the plate mass difference method, exhibits a transient behavior after each change of friction interface temperature level. The effect is hypothesized to be caused by a temperature-dependent change in the moisture content/mass level in the friction material. To test this hypothesis, a series of synchronized characterization experiments have been conducted by using two friction plates, one for wear tests and the other for drying in an oven under the same temperature conditions. Based on the analysis of test results, a moisture content compensation procedure, which reduces the transient wear rate from being 100% to being 50% higher compared to stabilized wear rate, is proposed and verified. The gained insights are used to set recommendations on the organization of routine wear characterization experiments aimed at avoiding the effect of moisture content influence on the accuracy of wear measurement. The main recommendations are to minimize the number of temperature target level changes through proper design of the experiment, insert a run-in test after every long test pause, and execute a pre-heat, blind wear test at the beginning of each test day.
The paper presents an experimentally validated regression model for dry clutch friction lining wear, accounting for the influence of clutch temperature, initial slip speed, torque, and closing time. The experimental data have been collected by using a custom-designed disk-on-disk computer-controlled tribometer and conducting repetitive real operation-like clutch closing cycles for different levels of the above operating parameters. The model is designed to be cycle-wise, predicting cumulative worn volume expectation and standard deviation after each closing cycle. It is organized around three distinctive submodels, which provide predictions of: (i) wear rate expectation, (ii) wear rate variance, and (iii) elevated wear rate during run-in operation. Finally, the wear rate expectation and variance submodels and the overall, cumulative worn volume model are validated on independent experimental datasets. The main novelty of the presented research lies in the development of stochastic multi-input cycle-wise dry cutch wear model for clutch design and monitoring applications.
21 February 2022 in International Journal of Automotive Technology
This paper presents a stochastic regression model for predicting the coefficient of friction (COF) in automotive dry clutches with organic linings. The influence of temperature, normal load, and slip speed on COF behaviour is investigated based on a large set of clutch wear-characterization data, collected using a custom-designed disc-on-disc tribometer that replicates realistic clutch-engagement cycles. The proposed model calculates both the expected value and standard deviation of the COF. The COF expectation model takes temperature, normal load, and slip speed as inputs, and it has a cubic polynomial form selected through a feature-selection method. The COF standard deviation model is fed by the same three inputs or alternatively the COF expectation input, and it is parameterized using the maximum likelihood method. The overall model is validated on an independent characterization dataset and an additional dataset gained through separate experiments designed to mimic real driving conditions.
1 May 2020 in Proceedings of the Design Society: DESIGN Conference
The design of an active seat suspension for a mid-class passenger vehicle based on the given set of requirements is considered a combination of four subsystems; the carrier, the actuator, the spring, and the damper. The design of the former two is considered through the 10 and 16 concepts for each, respectively. Two overall designs are proposed for further development. One based on a dual Scott-Russell mechanism and one based on Sarrus mechanism. The first one is evaluated to have high stiffness, the second to be more cost-effective. The detailed design of the first concept is presented.