This letter reports an Al 0.65 Ga 0.35 NAl 0.4 Ga 0.6 N metal-oxide-semiconductor-heterojunction- field-effect-transistor (MOSHFET) with an SiO 2 gate-insulator. For this first demonstration of an AlGaN channel MOSHFET, a new doped barrier epilayer design led to linear source-drain ohmic-contacts formed by Zr-based metal stack with a contact resistance as low as 1.64 Ω · mm. For a device with 6-μm source-drain opening a record saturation current of 0.6 A/mm (at gate bias of 6V) was measured. In contrast to a conventional Schottky-gate HFET, the gateoxide from the pulsed plasma enhanced chemical vapor deposition decreased the MOSHFET gate leakage current by a factor of 10 4 with only a 1.5-V shift in the threshold voltage. A drift mobility of 430 cm 2 /V · s is measured at zero-gate bias, which increases to 800 cm 2 /V·s close to the threshold voltage. The device characteristics up to 250°C are used to calculate the temperature dependence of the drift mobility.
We report on the demonstration of high current density in Al 0.65 Ga 0.35 N/Al 0.4 Ga 0.6 N heterojunction field effect transistors with micro-channels enabled by enhanced contact injection. Devices with a gate length of 100 nm exhibited a maximum current density of 910 mA/mm and a maximum transconductance of 140 mS/mm. A current gain cut off frequency of 20 GHz and maximum oscillation frequency of 36 GHz were obtained. Large-signal load-pull characterization of the transistors showed output power density of 2.7 W/mm at 10 GHz. The current density and output power density represent the state-of-art performance for high Al-composition AlGaN channel transistors.
We report on Al 0.65 Ga 0.35 N/Al 0.4 Ga 0.6 N metal oxide semiconductor heterojunction field-effect transistor (MOSHFET) with high- k ZrO 2 gate-dielectric deposited using atomic layer deposition process. As extracted from frequency dependent capacitance–voltage ( CV ) characteristics, the oxide gates resulted in an interfacial state trap density of ∼2 × 10 12 cm −2 . A comparative study, on the same material, shows the gate-leakage current of the ZrO 2 MOSHFETs to be lower by five orders; their ON/OFF current ratio (∼10 7 ) to be higher by about four orders and their threshold voltage to decrease (less negative) by 3.5 V with respect to the Schottky gate devices.
We present a study of the light output power and the thermal impedance of 281 nm emission AlGaN based micropixel LEDs. A modular interconnected micropixel array design is presented which enables dense packing with area and power scalability. We study 5–15 μm diameter stand-alone devices and parallel-connected micropixel arrays with 5 μm interpixel gaps. A standalone 5 μm pixel emits 291 W cm−2 at 10.2 kA cm−2 DC-drive. A power as high as 23 mW (361 W cm−2) was measured at a pulsed-pump current of 800 mA (∼15 kA cm−2) for an interconnected array. These are the smallest and brightest DUV LEDs to date.
We report on 193 nm excimer laser-based liftoff (LLO) of Al0.26Ga0.74N/GaN high electron mobility transistors (HEMTs) with thick (t > 10 μm) AlN heat spreading buffer layers grown over sapphire substrates. The use of the thick AlN heat spreading layer resulted in thermal resistance ( ) of 16 K mm/W for as-fabricated devices on sapphire, which is lower than the value of ∼25–50 K mm/W for standard HEMT structures on sapphire without the heat-spreaders. Soldering the LLO devices onto a copper heat sink led to a further reduction of to 8 K mm/W, a value comparable to published measurements on bulk SiC substrates. The reduction in by LLO and bonding to copper led to significantly reduced self-heating and drain current droop. A drain current density as high as 0.9 A/mm was observed despite a marginal reduction of the carrier mobility (∼1800 to ∼1500 cm2/V s). This is the highest drain current density and mobility reported to-date for LLO AlGaN/GaN HEMTs.