A humidity resistant and versatile fabrication method for the production of very high quality, organic-inorganic perovskite films, solar cells and solar modules is presented. By using ethyl acetate as an anti-solvent during deposition, perovskite solar cells with power conversion efficiencies (PCEs) up to 15% were fabricated in a 75% relative humidity (RH) environment. Ethyl acetate acts as a moisture absorber during spin-coating, protecting sensitive perovskite intermediate phases from airborne water during film formation and annealing. We have demonstrated the manufacture of 50 mm × 50 mm series interconnected modules with PCEs in excess of 10% for 13.5 cm2 devices processed in air at 75%RH and 11.8% at 50%RH. To the best of our knowledge, these results represent the highest efficiency for perovskite solar modules processed under high humidity ambient conditions. This new deposition protocol allows for low-cost, efficient and consistent device fabrication in humid climates and uncontrolled laboratories.
Perovskite photovoltaics have shown great promise in device efficiency but also the promise of scalability through solution‐processed manufacture. Efforts to scale perovskites have been taken through printable mesoporous scaffolds and slot die coating of flexible substrates roll‐to‐roll (R2R). However, to date there has been no demonstration of entirely R2R‐coated devices due to the lack of a compatible solution‐processable back electrode; instead, high‐value evaporated metal contacts are employed as a post process. Here, in this study, the combination of a low‐temperature device structure and R2R‐compatible solution formulations is employed to make a fully R2R printable device architecture overcoming interlayer incompatibilities and recombination losses. Therefore, the n–i–p device structure of SnO2/perovskite/poly(3,4‐ethylenedioxythiophene)/carbon is employed to form an ohmic contact between a p‐type semiconductor and printable carbon electrode. In particular, the results show that the small‐scale device efficiencies of 13–14% are achieved, matching the device performance of evaporated gold electrodes. Also, this entirely R2R‐coated perovskite prototype represents a game changer, reaching over 10% (10.8) stabilized power conversion efficiency with unencapsulated long‐term stability retaining 84% of its original efficiency over 1000 h under 70% RH and 25 °C.
Photovoltaic devices based on perovskite materials have a great potential to become an exceptional source of energy while preserving the environment. However, to enter the global market, they require further development to achieve the necessary performance requirements. The environmental performance of a pre-industrial process of production of a large-area carbon stack perovskite module is analyzed in this work through life cycle assessment (LCA). From the pre-industrial process an ideal process is simulated to establish a benchmark for pre-industrial and laboratory-scale processes. Perovskite is shown to be the most harmful layer of the carbon stack module because of the energy consumed in the preparation and annealing of the precursor solution, and not because of its Pb content. This work stresses the necessity of decreasing energy consumption during module preparation as the most effective way to reduce environmental impacts of perovskite solar cells.