The combination of two different metals, each of them acting on different steps of the oxygen reduction reaction (ORR), yields synergic catalytic effects. In this respect, the electrocatalytic effect of silver is enhanced by the addition of cobalt, which is able to break the O–O bond of molecular oxygen, thus accelerating the first step of the reduction mechanism. At the same time, research is to further reduce the catalyst’s cost, reducing the amount of Ag, which, even though being much less expensive than Pt, is still a noble metal. From this point of view, using a small amount of Ag together with an inexpensive material, such as graphite, represents a good compromise. The aim of this work was to verify if the synergic effects are still operating when very small amounts of cobalt (2–10 μg·cm−2) are added to the microparticles of silver electrodeposited on glassy carbon, described in a preceding paper from us. To better stress the different behaviour observed when cobalt and silver are contemporarily present in the deposit, the catalytic properties of cobalt alone were investigated. The analysis was completed by the Levich plots to evaluate the number of electrons involved and by Tafel plots to show the effects on the reaction mechanism.
Technological development in nanoelectronics and solar energy devices demands nanostructured surfaces with controlled geometries and composition. Electrochemical atomic layer deposition (E-ALD) is recognized as a valid alternative to vacuum and chemical bath depositions in terms of growth control, quality and performance of semiconducting systems, such as single 2D semiconductors and multilayered materials. This chapter is specific to the E-ALD of metal chalcogenides on Ag single crystals and highlights the electrochemistry for the layer-by-layer deposition of thin films through surface limited reactions (SLRs). Also discussed herein is the theoretical framework of the under potential deposition (UPD), whose thermodynamic treatment open questions to the correct interpretation of the experimental data. Careful design of the E-ALD process allows fine control over both thickness and composition of the deposited layers, thus tailoring the optoelectronic properties of semiconductor compounds. Specifically, the possibility to tune the band gap by varying either the number of deposition cycles or the growth sequence of ternary compounds paves the way toward the formation of advanced photovoltaic materials.