The article discusses the use of pivot bearing friction liners, made of selected materials, in railway freight wagons’ spherical centre bowls. Comparative studies on the effect of suspension dynamics on the equivalent stresses in the liner material were carried out using the finite element method and multibody simulation. The results show the magnitude and location of the highest stresses in the liner with varying input loads, friction coefficients and interacting materials. The analysis is a basis for a simulation method for predicting the fatigue life of the suspension friction liner placed in the centre bowl between the bogie frame and the vehicle body.

One of the assumptions made during the modernization process of diesel shunting locomotives is the replacement of a diesel traction motor with a DC generator with an electric asynchronous traction motor. The article aimed to develop a method of selecting energy-efficient parameters of an asynchronous electric traction motor for diesel shunting locomotives, which will ensure that its operating energy efficiency will be as high as possible. The method was verified on the example of a locomotive series ChME3 (ЧMЭ3, ČME3, ČKD S200). It has been found that using a traction asynchronous electric drive on a ChME3 locomotive, its efficiency increases in comparison with DC electric motors by 3–5% under the long-term operation modes and by 7–10% during locomotive operation with traction at the adhesion limit. Using a new traction gearbox with a higher gear ratio expands the speed range in which the asynchronous traction drive operates with a high-efficiency factor. It is effective to use a traction asynchronous electric drive to modernize ChME3 diesel locomotives in case of their use under the modes requiring the implementation of maximum traction forces at low speeds. A further increase in the efficiency of the traction asynchronous electric drive is possible based on the optimal design of the wheel-motor unit and the asynchronous traction electric drive.

This paper investigates the influence of the models of dry friction suspension component used in the numerical simulation of freight car dynamics on the possible predictions related to safety against derailment. Moreover, the performance of the models is compared on the basis of simulation runtime. Three groups of static and dynamic models of friction are selected as three different approaches which are often utilized in popular multibody simulation tools. The models are used for the centre bowl friction joint between the car body and bogies. The friction torque in the centre bowl affects the rotational resistance of the bogie in motion relative to the car body and consequently influences the interaction forces between the wheels and rails. Simulation results of safety against derailment index obtained from the vehicle curving scenario suggest noticeable differences in predictions of the selected models of friction.