Significance: The motion of granular materials, e.g., sand or catalytic particles, underlies many natural and industrial processes. Granular dynamics are difficult to understand and model because of transitions between solid-, liquid-, and gas-like behavior, and prior continuum models have struggled to capture these transitions. Bubble-like voids normally rise chaotically through grains suspended by upward gas flow. We create structured bubble formations by vibrating the system at a resonant frequency, independent of particle properties or system size, and we identify salient physics using a harmonic oscillator model. We propose a constitutive relationship that enables continuum models to predict structured bubbling a priori by capturing fluid–solid transitions. The continuum model and controlled bubble patterning can advance scale-up and optimization of industrial processes.
Image reconstruction plays a key role in the application of electrical capacitance tomography (ECT). Although many different algorithms have been developed in the past, it is often difficult to obtain satisfactory images in all imaging regions by the use of a single algorithm due to the soft-field nature of ECT. This motivated us to develop a novel ECT image reconstruction strategy, in which a high-quality image can be obtained by combining the images reconstructed by two different algorithms via a graph cut method. By doing so, it is possible to retain the advantage of each algorithm for specified imaging regions and improve the quality of the whole image. This strategy was verified both numerically and experimentally for two widely used ECT reconstruction algorithms, i.e., linear backprojection and Tikhonov regularization. The results for stationary objects as well as gas-solid fluidized beds demonstrated that this graph-cut-based combination strategy presents a promising approach for ECT image reconstruction.
23 August 2018 in Measurement Science and Technology
Electrical capacitance tomography (ECT) is a non-intrusive and non-invasive imaging technique for the visualisation of material distribution, e.g. in a gas–solid fluidised bed. So far, ECT has been successfully used in gas–solid fluidised beds at ambient temperature. However, ECT has been rarely used in high-temperature gas–solid fluidised beds, which is of practical importance in many applications. Considering that most fluidised bed reactors are operated at high temperature, it is necessary to investigate the application of ECT in high-temperature industrial processes. In this work, a high-temperature ECT sensor, which can withstand 1073 K, is designed and fabricated. It has been verified by three stationary objects. The results show that the ECT sensor can give satisfactory images at different high-temperature levels and the change in temperature has little effect on the signal-to-noise ratio. It has also been found that the minimum bubbling velocity estimated by ECT is the same as that obtained by pressure drop measurements, and two fluidisation regimes, i.e. bubbling and slugging can be identified by ECT.