Several methods to synthesize poly(phenylene) block copolymers through the nickel coupling reaction were attempted to reduce the use of expensive nickel catalysts in polymerization. The model reaction for poly(phenylene) having different types of dichlorobenzene derivative monomers illustrated the potential use of cost-effective catalysts, such as NiBr2 and NiCl2, as alternatives to more expensive catalysts (e.g., bis(1,5-cyclooctadiene)nickel(0) (Ni(COD)2)). By catalyzing the polymerization of multi-block poly(phenylene) with NiBr2 and NiCl2, random copolymers with similar molecular weights could be prepared. However, these catalysts did not result in a high-molecular-weight polymer, limiting their wide scale application. Further, the amount of Ni(COD)2 could be reduced in this study by approximately 50% to synthesize poly(phenylene) multi-block copolymers, representing significant cost savings. Gel permeation chromatography and nuclear magnetic resonance results showed that the degree of polymerization and ion exchange capacity of the copolymers were almost the same as those achieved through conventional polymerization using 2.5 times as much Ni(COD)2. The flexible quaternized membrane showed higher chloride ion conductivity than commercial Fumatech membranes with comparable water uptake and promising chemical stability.
Sulfonated poly(phenylene-co-arylene ether sulfone) multiblock copolymers are synthesized via Colons nickel-mediated cross-coupling reaction and are investigated as a proton-exchange membrane fuel cell. To investigate the influence of the fluorine moieties on the membrane properties, two different membranes are prepared, one containing a fluorinated hydrophobic poly(arylene ether) block (6F polymer membrane) and a nonfluorinated biphenyl (BP) polymer membrane. The proton transport, morphology, mechanical properties, and oxidative stabilities of the membranes are examined in relation to the ion-exchange capacity (IEC). 6F polymer membranes show superior proton conductivity and oxidative stability (results of Fentons oxidative stability and hydrogen peroxide exposure tests) compared with the BP polymer membranes. In water at 25C, 6F and BP polymer membranes with IEC 2.0meqg–1 exhibit proton conductivity of 0.11Scm–1 with 6F having 16 lower water uptake than BP polymer. Meanwhile, at 30 RH and 80C, 6F-X5Y9-(2.0) exhibits proton conductivity of 0.0026Scm–1 that almost 50 higher than BP-X5Y7-(2.0) with 0.0018Scm–1, while at 90 RH and 80C, both polymers have an almost similar value of 0.10Scm–1. Oxidative stability with the Fenton test under harsh conditions demonstrates that 6F-X5Y9-(2.0) has an extent degradation of 26, almost 19 lower than BP-X5Y7-(2.0) with 32, and the hydrogen peroxide exposure test demonstrates that 6F has 50 lower extent of degradation than BP with 5 and 9, respectively. Fuel cell performance test at 80C and 100 RH show that 6F-X5Y9-(2.0) exhibits a current density of 1.6 A cm–2 at 0.6V (hydrogen/air) and outperforms Nafion-NR211 and BP-X5Y7-(2.0), 1.4 A cm–2 and 1.2 A cm–2, respectively. Undoubtedly, incorporating fluorinated moieties could enhance proton transport properties and oxidative stability favorable for fuel cell application.