Robert Cattrall

Prof. Dr. Robert Cattrall

<sup>1</sup> Department of Chemistry and Physics, La Trobe University, Bundoora, Victoria 3086, Australia<br/><sup>2</sup> School of Chemistry, The University of Melbourne, Victoria 3010, Australia

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 December 2015 in Membranes
Verified
Journal Article
Open access
PDF file
YBYa Ya Nutchapurida Bonggotgetsakul
Ya Ya Nutchapurida Bonggotgetsakul
RCRobert Cattrall
Robert Cattrall
Spas Dimitrov KolevSpas Dimitrov Kolev
Spas Dimitrov Kolev
Poly(vinyl chloride) (PVC) based polymer inclusion membranes (PIMs), with different concentrations of Cyphos® IL 104 as the membrane extractant/carrier, were studied for their ability to extract Au(III) from hydrochloric acid solutions. Some of the PIMs also contained one of the following plasticizers or modifiers: 2-nitrophenyloctyl ether, dioctylphthalate, 1-dodecanol, 1-tetradecanol, or tri(2-ethylhexyl) phosphate. The best performance, in terms of extraction rate and amount of Au(III) extracted, was exhibited by a PIM consisting of 25 wt% Cyphos® IL 104, 5 wt% 1-dodecanol, and 70 wt% PVC. An almost complete back-extraction of the Au(III) extracted from this membrane was achieved by using a 0.10 mol L−1 Na2SO3 receiver solution at pH 8. The stoichiometry of the extracted Au(III)/Cyphos® IL 104 adduct was determined as [P]+ [AuCl4]− H+ [PO2]− where [P]+ and [PO2]− represent trihexyl(tetradecyl) phosphonium and bis(2,4,4-trimethylpentyl) phosphinate ions, respectively. Back-extraction of Au(III) is suggested to occur by reduction of Au(III) to Au(I), with the formation of the species [Au(SO3)2]3− in the aqueous receiver solution. Loss of 1-dodecanol from the newly developed PIM to the aqueous solutions in contact with it was observed, which indicated that this membrane was suitable for single use in the efficient recovery of Au(III) from hydrochloric acid solutions of electronic scrap or recycled jewelry.

1 June 2019 in Food Chemistry
Verified
Journal Article
Closed access
RVRuben Vera
Ruben Vera
Yanlin ZhangYanlin Zhang
Yanlin Zhang
Clàudia FontàsClàudia Fontàs
Clàudia Fontàs
M. Inês G. S. AlmeidaM. Inês G. S. Almeida
M. Inês G. S. Almeida
Enriqueta AnticóEnriqueta Anticó
Enriqueta Anticó
Spas Dimitrov KolevSpas Dimitrov Kolev
Spas Dimitrov Kolev

26 October 2017 in Electrospinning
Verified
Journal Article
Open access
PDF file
YOYukie O’bRyan
Yukie O’bRyan
Yen TruongYen Truong
Yen Truong
RCRobert Cattrall
Robert Cattrall
IKIllias L. Kyratzis
Illias L. Kyratzis
Spas Dimitrov KolevSpas Dimitrov Kolev
Spas Dimitrov Kolev
A new extracting polymer wool was prepared from polystyrene (PS) and the commercial extractant Aliquat 336 by electrospinning and its potential as a packing material for an online preconcentration column in an automated flow injection system was investigated for the determination of thiocyanate (SCN−). The formation of the wool fibres was confirmed by scanning electron microscopy (SEM). The polymer wool was inserted into a glass tube to prepare a column. SCN− solutions of different volumes (2-10 mL) were passed through the fibre-packed column where SCN− was extracted by the fibres. The columnwas then eluted with a small volume of 1MNaNO3 solution. The eluatewas mixed with an iron(III) solution and the resulting coloured complex (FeSCN2+) was detected colorimetrically. The system successfully achieved 21-fold preconcentration of SCN−. A linear calibration curve was obtained in the range from 0.02 to 1.0 mg L−1 SCN− with a sampling rate of 9 h−1. To the authors’ best knowledge this is the first time electrospun fibres containing a liquid extractant have been used for preconcentration in a flow analysis system.

25 January 2018 in Membranes
Verified
Journal Article
Open access
PDF file
YBYa Ya N. Bonggotgetsakul
Ya Ya N. Bonggotgetsakul
RCRobert Cattrall
Robert Cattrall
Spas Dimitrov KolevSpas Dimitrov Kolev
Spas Dimitrov Kolev
Clusters of gold nanoparticles (AuNPs) formed on the surface of PVC-based polymer inclusion membranes (PIMs) with a liquid phase containing Aliquat 336 as the carrier and in some cases 1-dodecanol or 2-nitrophenol octyl ether as plasticizers were found to inhibit the extraction of nitrate by the PIMs. This observation was based on gradually increasing the mass of AuNPs on the membrane surface and testing the ability of the membrane to extract nitrate after each increase. In this way, it was possible to determine the so-called “critical AuNP masses” at which the studied membranes ceased to extract nitrate. On the basis of these results, it can be hypothesized that the surfaces of these PIMs are not homogeneous with respect to the distribution of their membrane liquid phases, which are present only at certain sites. Extraction takes place only at these sites, and at the “critical AuNP mass” of a PIM, all these extraction sites are blocked and the membrane loses its ability to extract.

10 April 2014 in Methods and Applications in Fluorescence
Verified
Journal Article
Closed access
CHClare A Henderson
Clare A Henderson
Edward A. NagulEdward A. Nagul
Edward A. Nagul
RCRobert Cattrall
Robert Cattrall
Spas Dimitrov KolevSpas Dimitrov Kolev
Spas Dimitrov Kolev
TSTrevor Smith
Trevor Smith
Polymer inclusion membranes (PIMs) transport chemicals between bodies of liquid by simultaneously performing chemical extraction and back-extraction. The internal chemical and physical mechanisms by which this transport occurs are, however, poorly understood. Also, some PIMs, which are otherwise optimal for their task, age and lose function after only days, limiting their feasibility for industrial upscaling. Through the application of fluorescence imaging methods we are able for the first time to see where chemical extraction occurs in the membrane. Extraction of fluorescein from solution by PIMs demonstrates inhomogeneities that do not correlate to surface morphology. Fluorescence lifetime imaging demonstrates that regions of increased extraction have distinctly different fluorescence lifetimes to that of the surrounding PIM indicating localized chemical environments, and this is observed to change with membrane age. Fluorescence imaging is shown to allow probing and novel understanding of PIM internal chemical morphology.

5 March 2004 in Talanta
Verified
Journal Article
Closed access
NANazanin Amini
Nazanin Amini
TCTerence J Cardwell
Terence J Cardwell
RCRobert Cattrall
Robert Cattrall
RMRichard J.S Morrison
Richard J.S Morrison
Spas Dimitrov KolevSpas Dimitrov Kolev
Spas Dimitrov Kolev