This article presents a compact 2× time-interleaved switched-capacitor (SC) digital-to-analog converter (DAC) for digital-intensive transmitter architectures. To minimize area and to leverage the strengths of FinFET technology, the implementation departs from the traditional current steering approach and consists mainly of inverters and sub-femtofarad SCs. The DAC's architecture is based on parallel charge redistribution and separates level generation, pulse timing, and output power generation. The described 28-GS/s 8-bit prototype design occupies 0.03 mm 2 in 16-nm CMOS and supports up to 0.32- V pp signal swing across its differential 100- Ω load. It achieves an SFDR ≥ 37 dB and an IM 3 ≤ -45.6 dBc across the first Nyquist zone while consuming 88 mW from a single 0.8-V supply.
23 June 2015 in Analog Integrated Circuits and Signal Processing
The data rate-times-distance product in mm-wave dielectric waveguide communication links is usually limited by waveguide dispersion. This paper presents the dielectric waveguide’s baseband impulse response in the context of a homodyne receiver, and introduces a continuous-time linear equalizer able to minimize such dispersion. The desired transfer function is implemented with inverter-based transconductance cells. Simulation and measurement results at 10 Gbps data rate show eye-opening improvement at two distances (10 m and 15 m) and carrier frequencies (140 GHz and 160 GHz). The equalizer occupies 80 x 32 μm in GLOBALFOUNDRIES 22 nm FD-SOI.
An inverter‐based track‐and‐hold circuit that merges the functions of buffering and sampling is proposed, simultaneously improving linearity, bandwidth and power efficiency when compared to state‐of‐the‐art designs. The circuit operation and its governing equations are presented, and simulation results of an 80 GS/s, 5.5 ENOB time‐interleaved prototype consuming 25 mW from a 0.7 V supply demonstrate the advantages of the proposed topology using a predictive 7 nm FinFET CMOS technology.
4 April 2016 in Analog Integrated Circuits and Signal Processing
A multi-frequency bioimpedance measurement prototype is proposed, validated and characterized. It consists of an Improved Howland Current Source controlled by voltage, a load voltage sensing scheme through a discrete 3-opamp instrumentation amplifier, a phase and quadrature demodulation setup through analog multipliers, and digitization and processing of the signals using a digital benchtop multimeter. The electrical characterization of the measurement channel was done for resistive loads only, on four different circuits. Measurements were made on 10 frequencies, from 100 kHz to 1 MHz, with 10 load resistances, from 100 Ω to 1 kΩ, to obtain linearity, absolute error and frequency response. The best performance among the four circuits was a maximum absolute error of 5.55 %, and −1.93 % of load current variation at the worst case scenario.