Temperature gradient type ESSO test is one of the most popular test methods for evaluating the brittle crack arrest toughness, \(K_{ca}\). However, test conditions which are specimen shape, tab plate shape, applied stress and temperature gradient affect \(K_{ca}\). This document reports effects of specimen geometries that are specimen width, tab plate length, tab plate thickness and tab plate width on \(K_{ca}\) evaluation. In addition, effects of applied stress and temperature gradient have also been investigated. Temperature gradient type ESSO tests are conducted at three different steel mills in Japan. Then, test conditions were varied and test results were compared. In the result, influence range of effect specimen width, tab plate thickness, applied stress and temperature gradient were demonstrated. The applicable range of specimen geometry, applied stress and temperature gradient were clarified and implemented to the brittle crack arrest standard.
Studies have suggested that brittle fractures occur in steel because microcracks in the brittle layer at grain boundaries propagate as a result of the increase in piled-up dislocations. Therefore, prestraining can approach the limits of a material, which could lead to a decrease in fracture toughness. However, strains are tensors comprising multiple components, so the effect of prestrain on fracture toughness is not simple. Additionally, the mechanism of change in critical stress due to prestrain has not been thoroughly investigated. For the lifetime evaluation of steel structures with a complicated load history, it is important to generalize the effect of complicated prestrain on the decrease in fracture toughness. In this paper, a single prestrain was applied in a direction different from the crack opening direction. A general three-point bending test was employed for fracture evaluation. Numerical analyses using the strain gradient plasticity (SGP) theory, which is a method based on the finite element method (FEM) are carried out; conventional macroscopic material damage rules are considered as well. Using these FEM analyses, the critical stress is calculated. Finally, the change in critical stress can be expressed by the yield point increase and dislocation density and formulated based on the identified micromechanisms.