Zr-containing metal-organic frameworks (MOFs) exhibit a good performance of catalyzing the hydrolysis of chemical warfare agents, which is closely related to the size of MOF particles and its defects, but these two factors are often intertwined. In this article, we synthesized UiO-66-NH2 nanoparticles using a microwave-assisted hydrothermal method. By using a new modulator 4-Fluoro-3-Formyl-Benzoic Acid (FFBA) in different proportions, MOF particles with the same defect degree but different scales and those with similar sizes but different defect degrees can be obtained. The performance of the obtained MOF particles to catalyze the hydrolysis of the nerve agent simulant, dimethyl 4-nitrophenyl phosphate (DMNP), was investigated, and the effects of single factors of size or defect were compared for the first time. As the size of the obtained MOF particles increased from 81 nm to 159 nm, the catalytic degradation efficiency toward DMNP gradually decreased, and the half-life increased from 3.9 min to 11.1 min. For MOFs that have similar crystal sizes, the catalytic degradation half-life of MOF3 is only 5 min, which is much smaller than that of MOF5 due to the defects increase from 1.2 to 1.8 per Zr6 cluster.
Herein, a facile dopamine assisted one-pot synthesis approach is proposed for the preparation of porous carbon with a specific surface area (SSA) up to 2593 m2/g through the direct pyrolysis of a mixture of glucose, NH4Cl, and dopamine hydrochloride (DAH). The glucose is adopted as the carbon source and foaming agent, NH4Cl is used as the blowing agent, and DAH is served as collaborative carbon precursor as well as the nitrogen source for the first time. The effect of dopamine on the component, structure, and SSA of the as-prepared porous carbon materials are systematically studied. The moderate addition of dopamine, which influences the condensation and polymerization of glucose, matches better with ammonium salt decomposition. The SSA of porous carbon increases first and then decreases with the increasing amount of dopamine. In our case, the porous carbon produced with 5 wt% dopamine (PC-5) achieves the maximum SSA of up to 2593 m2/g. Accordingly, it also shows the greatest electrochemical performance. The PC-5 shows a capacitance of 96.7 F/g calculated from the discharge curve at 1 A/g. It also has a good capacitive rate capacity, the specific capacitance can still maintain 80%, even at a high current density of 10 A/g. Moreover, PC-5 exhibits a good cycling stability of 98.1% capacitive retention after 1000 cycles. The proposed method may show promising prospects for preparing porous carbon materials as advanced energy storage materials, storage, and catalyst supports.
Chemical warfare agents (CWAs) refer to toxic chemical substances used in warfare. Recently, CWAs have been a critical threat for public safety due to their high toxicity. Metal–organic frameworks have exhibited great potential in protecting against CWAs due to their high crystallinity, stable structure, large specific surface area, high porosity, and adjustable structure. However, the metal clusters of most reported MOFs might be highly consumed when applied in CWA hydrolysis. Herein, we fabricated a two-dimensional piezoresponsive UiO-66-F4 and subjected it to CWA simulant dimethyl-4-nitrophenyl phosphate (DMNP) detoxification under sonic conditions. The results show that sonication can effectively enhance the removal performance under optimal conditions; the reaction rate constant k was upgraded 45% by sonication. Moreover, the first-principle calculation revealed that the band gap could be further widened with the application of mechanical stress, which was beneficial for the generation of 1O2, thus further upgrading the detoxification performance toward DMNP. This work demonstrated that mechanical vibration could be introduced to CWA protection, but promising applications are rarely reported.