In this paper, the non-ideal factors, which include spatial noise and temporal noise, are analyzed and suppressed in the high-speed spike-based image sensor, which combines the high-speed scanning sequential format with the method that uses the interspike time interval to indicate the scene information. In this imager, spatial noise contains device mismatch, which results in photo response non-uniformity (PRNU) and the non-uniformity of dark current. By multiplying the measured coefficient matrix the photo response non-uniformity is suppressed, and the non-uniformity of dark current is suppressed by correcting the interspike time interval based on the time interval of dark current. The temporal noise is composed of the shot noise and thermal noise. This kind of noise can be eliminated when using the spike frequency to restore the image. The experimental results show that, based on the spike frequency method, the standard deviation of the image decreases from 18.4792 to 0.5683 in the uniform bright light by using the calibration algorithm. While in the relatively uniform dark condition, the standard deviation decreases from 1.5812 to 0.4516. Based on interspike time interval method, because of time mismatch and temporal noise, the standard deviation of the image changes from 27.4252 to 27.4977 in the uniform bright light by using the calibration algorithm. While in the uniform dark condition, the standard deviation decreases from 2.361 to 0.3678.
The output features of pixels in CMOS image sensors (CISs) are influenced by different exposure conditions. This paper presents an analytical model to describe the output characteristics of the exposure process in pinned photodiode (PPD) CMOS image sensors with the accumulation of three charge sources: photogenerated charge, p-n junction-generated charge, and emission charge. In the proposed model, the difference between the time-based and light intensity-based photo response process is illustrated. The model also reveals the relationship between photodiode potential and light intensity at different exposure values. At the low exposure values, the PD potential increases with light intensity, and a contrary trend is observed at the high exposure values. This concludes that a larger linear output range can be obtained in high light intensity conditions. Furthermore, the improved model provides development analysis in terms of light intensity influence for long exposure time noise. The models were verified with technology computer-aided design simulation and the test devices were fabricated using a 0.18-μm CIS process. The model demonstrates good consistency with simulation and measured results.
This paper proposed a fully integrated charge pump circuit for HDR CMOS image sensors. The proposed circuit uses a cross-coupled structure and utilizes pseudo continuous modulation technology so that it exhibits low ripple and fast transient response. The gate source and the gate drain voltage of each transistor are efficiently regulated and will not cause transistor damage and aging. This design is implemented in a 0.11 μm process, layout area is 0.036mm 2 . The simulation results show the proposed charge pump achieves a recovery time (99.9%) of 66 ns with an undershoot of 127 mV while maintaining a steady-state ripple of less than 0.59 mVpp. The charge pump consumes a total power of 1.121 mW, ensuring energy-efficient operation.
Indirect time-of-flight depth sensor can obtain depth from the phase offset between emitted and received modulated infrared (IR) pulsed light. However, these sensors suffer from motion blur artifacts when there are moving objects in the scene causing depth measurement distortion. By analyzing the mechanism of motion blur, this paper summarizes motion blur into categories: half-frame motion blur and full-frame motion blur. For both blur categories, this paper respectively proposes the deblurring method based on charge correction with the adjacent frame charge reference and the neighborhood similar charge reference. Based on the range resolution equation, the proposed pixel-based blur detection method can adaptively detect motion blur. For detected blurred pixels, the proposed deblurring method removes blur by recalculating the depth of blurred pixels. Motion blur was suppressed at 30 fps owing to the proposed deblurring method. The depth error is about 1.68% over the range of 1-2m, with a modulation frequency of 40 MHz. Experimental results demonstrate that the proposed deblurring method can effectively eliminate the motion blur of moving objects with minimal computational cost.