Alaa El-Din Hussein

Dr. Alaa El-Din Hussein

orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 February 2019 in Sustainability
Verified
Journal Article
Open access
PDF file
Md Shafiul AlamMd Shafiul Alam
Md Shafiul Alam
Mohamed AbidoMohamed Abido
Mohamed Abido
AHAlaa El-Din Hussein
Alaa El-Din Hussein
IEIbrahim El-Amin
Ibrahim El-Amin
This paper proposes a non-superconducting bridge-type fault current limiter (BFCL) as a potential solution to the fault problems of doubly fed induction generator (DFIG) integrated voltage source converter high-voltage DC (VSC-HVDC) transmission systems. As the VSC-HVDC and DFIG systems are vulnerable to AC/DC faults, a BFCL controller is developed to insert sizeable impedance during the inception of system disturbances. In the proposed control scheme, constant capacitor voltage is maintained by the stator VSC (SVSC) controller, while current extraction or injection is achieved by rotor VSC (RVSC) controller. Current control mode-based active and reactive power controllers for an HVDC system are developed. Balanced and different unbalanced faults are applied in the system to show the effectiveness of the proposed BFCL solution. A DFIG wind-based VSC-HVDC system, BFCL, and their controllers are implemented in a real time digital simulator (RTDS). The performance of the proposed BFCL control strategy in DFIG-based VSC-HVDC system is compared with a series dynamic braking resistor (SDBR). Comparative RTDS implementation results show that the proposed BFCL control strategy is very efficient in improving system fault ride through (FRT) capability and outperforms SDBR in all cases considered.

21 January 2021 in Arabian Journal for Science and Engineering
Verified
Journal Article
Closed access
PDF file
MEM. A Mohammed Eltoum
M. A Mohammed Eltoum
AHAlaa El-Din Hussein
Alaa El-Din Hussein
Mohamed AbidoMohamed Abido
Mohamed Abido

5 January 2025 in Case Studies in Thermal Engineering
Verified
Journal Article
Open access
HTH. Tella
H. Tella
AHAlaa El-Din Hussein
Alaa El-Din Hussein
Shafiqur RehmanShafiqur Rehman
Shafiqur Rehman
BLB. Liu
B. Liu
ABA. Balghonaim
A. Balghonaim
MMM. Mohandes
M. Mohandes

1 November 2022 in Energies
Verified
Journal Article
Open access
PDF file
Shafiqur RehmanShafiqur Rehman
Shafiqur Rehman
MMMohamed Mohandes
Mohamed Mohandes
AHAlaa El-Din Hussein
Alaa El-Din Hussein
LAL. M. Alhems
L. M. Alhems
AAAli Al-Shaikhi
Ali Al-Shaikhi
This study demonstrates that a drone flying above photovoltaic (PV) panels can clean the dust and enhance the panels’ efficiency. If operated regularly, the drone’s downward thrust generated during its cruise at a certain height above the panels can remove most of the accumulated dust. Sandstorms are frequent in Saudi Arabia, creating dust deposition on PV panels, which acts as a shield against solar radiation. As a result, the energy absorption from solar radiation is reduced and subsequently, the panels’ energy output is reduced. This experimental investigation was conducted at KFUPM University’s beach, Dhahran, Saudi Arabia, to prove the effectiveness of drone-based cleaning of PV panels. Volumes of 20, 50, and 100 CC of dust were spread on the panel during different experiments. These experimental results showed that the back thrust of the drone could remove most of the dust and improve the solar panels’ energy output performance. For example, for 50 CC dust spread on the panel, the current increased from 1.34 A to 2.16 A (61.2% increase), relative to the pre- and post-drone flight for horizontal movement of the drone. Similarly, for vertical and diagonal movements, the current increased by 69.83% and 68.03%, respectively, for a dust spread of 20 CC. Furthermore, dust reductions of 74.64%, 57.0%, and 78.4% were realized during the horizontal, vertical, and diagonal paths, respectively, of the drone flight for 50 CC dust spread.

3 July 2012 in Circuits, Systems, and Signal Processing
Verified
Journal Article
Closed access
PDF file
MAMunir Ahmad Al-Absi
Munir Ahmad Al-Absi
AHAlaa El-Din Hussein
Alaa El-Din Hussein
MTMuhammad TaherAbuelma’atti
Muhammad TaherAbuelma’atti

22 February 2019 in Energies
Verified
Journal Article
Open access
PDF file
Md Shafiul AlamMd Shafiul Alam
Md Shafiul Alam
Mohamed AbidoMohamed Abido
Mohamed Abido
AHAlaa El-Din Hussein
Alaa El-Din Hussein
This paper proposes a non-linear control-based variable resistive bridge type fault current limiter (VR-BFCL) as a prospective solution to ease the effect of disturbances on voltage source converter-based high voltage DC (VSC-HVDC) systems. A non-linear controller for VR-BFCL has been developed to insert a variable optimum resistance during the inception of system disturbances in order to limit the fault current. The non-linear controller takes the amount of DC link voltage deviation as its input and provides variable duty to generate a variable effective resistance during faults. The VSC-HVDC system’s real and reactive power controllers have been developed based on a current control loop where direct axis and quadrature axis currents are used to control the active and reactive power, respectively. The efficacy of the proposed non-linear control-based VR-BFCL solution has been proved with balanced as well as unbalanced faults. The results confirm that the oscillations in active power and DC link voltage have been significantly reduced by limiting the fault current through the insertion of an optimum effective resistance with the proposed control technique. The real time digital simulator (RTDS) has been used to implement the proposed approach. The performance of the proposed non-linear control based VR-BFCL is compared with that of traditional fixed duty control.