Fritz Trimpe

Dr. Fritz Trimpe

DB Systemtechnik GmbH
+1
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 February 2020 in Vehicle System Dynamics
Verified
Journal Article
Closed access
FTFritz Trimpe
Fritz Trimpe
CSCorinna Salander
Corinna Salander
Stability verification of railway wheelsets in Germany can currently become a process difficult to plan. Besides standardised calculations, expensive and often time-consuming test ride measurements have to be conducted. In particular, determining the maximum dynamic torsional stresses resulting from torsional vibration of wheelsets is a frequently discussed topic. Neither an analytical nor an empirical model has been found yet to predict the named stresses. Actually, they are determined experimentally and the representativeness of the recorded maximum dynamic torque is assured statistically. However, statistical evaluation only deals with axle stresses (torque and bending) itself. The origin of torsional vibration, which is the wheel–rail contact point, is not considered for evaluation. Its conditions are typically described by wheel–rail adhesion characteristics, but normally the necessary quantities describing these characteristics are not measured or not measured in sufficient precision. Therefore, this article analyses high-resolution wheel–rail adhesion data that have been recorded additionally on regular test ride measurements. The analysis of these measurement data leads to the following two correlations: (1) Torsional vibration events occur at a certain ratio of adhesion change and slippage change. (2) Dynamic torque swings up within a characteristic time span.

25 December 2020 in Vibration
Verified
Journal Article
Open access
PDF file
FTFritz Trimpe
Fritz Trimpe
Sönke LückSönke Lück
Sönke Lück
RNRolf Naumann
Rolf Naumann
CSCorinna Salander
Corinna Salander
For the stability verification of railway wheelsets in Germany, dynamic torsional stresses must be respected as they affect the axle and press fit stability of a wheelset. These dynamic stresses are applied to a wheelset by torsional vibration. However, dynamic stresses cannot be predicted by calculation, and so time-consuming and cost-intensive test runs are performed to measure the maximum dynamic stresses. Therefore, this article deals with the setup of a simulation model that shall enable the simulative prediction of maximum dynamic torsional stresses. This model respects that vibration excitation originates from the wheel-rail contact point and that the vibration energy input comes from a high-frequency drive train control. The first results show successful simulation of vibration excitation and correlations between adhesion change and maximum dynamic stresses.

8 September 2022 in Vibration
Verified
Journal Article
Open access
PDF file
Ahmed AbouzeidAhmed Abouzeid
Ahmed Abouzeid
FTFritz Trimpe
Fritz Trimpe
Sönke LückSönke Lück
Sönke Lück
MTMarkus Traupe
Markus Traupe
JMJuan Manuel Guerrero Muñoz
Juan Manuel Guerrero Muñoz
FBFernando Briz
Fernando Briz
Torsional vibration is an oscillation phenomenon occurring at driven railway vehicle wheelsets. As the resulting dynamic stresses can be significantly larger than the maximum static motor torque, axle and press fit are at risk of failure. To prevent dangerous vibration events and with these, press fit and axle from failure, traction drive manufactures nowadays used to implement vibration suppression algorithms in drive controls. In this paper, the effectiveness of such suppression algorithms is analyzed. Furthermore, as a pilot survey, we analyze to what extend traction controls influence the excitation of torsional vibration.