To study the dynamic plastic properties of high-purity molybdenum materials at high temperature and high strain rate, we designed tests to compare the mechanical behaviour of two high-purity molybdenum materials with different purities and two with different processing deformation conditions under dynamic impact compression in the temperature range of 297–1273 K. We analysed the molybdenum materials’ sensitivities to the strain-hardening effect, strain rate-strengthening effect, and temperature-softening effect as well as the comprehensive response to the combined effect of the strain rate and temperature, the adiabatic impact process, and the microstructure at high temperature and high strain rate. Furthermore, based on a modified Johnson–Cook constitutive model, we quantitatively analysed the flow stresses in these materials. The calculation results strongly agree with the test results. Our findings indicate that the high-purity molybdenum materials show consistent sensitivity to the combined effect of strain rate and temperature regarding the dynamic plastic properties. The materials with higher purity are less sensitive to the combined effect of the strain rate and temperature, and those with less processing deformation experience more pronounced strain-hardening effects. Under high strain rate at room temperature, these materials are highly susceptible to impact embrittlement and decreases in dynamic plastic properties due to intergranular fracture in the internal microstructure. However, increasing the impact environment temperature can significantly improve their plastic properties. The higher the temperature, the better the plastic properties and the higher the impact toughness.

This study investigated the deformation behavior of the Mo-10Ta alloy with a strain rate range of 10²–10⁵ s⁻¹. The Split Hopkinson pressure bar (SHPB) experiments were conducted to investigate the influence of deformation conditions on the stress-strain relationship and strain rate sensitivity of the material within a strain rate range of 0.001–4500 s⁻¹. The Shaped Charge Jet (SCJ) forming experiments under detonation loading was conducted to clarify the dynamic response and microstructure evolution of the material within an ultra-high strain rates range of 10⁴–10⁵ s⁻¹. Based on the stress-strain relationship of Mo-10Ta alloy at high temperature (286–873 K) and high strain rate (460–4500 s⁻¹), the influence of temperature and strain rate on the activation energy Q was analyzed. The results indicate that the material strain rate sensitivity increased with the increase in strain rate and strain. Meanwhile, the activation energy Q decreased as the temperature and strain rate increased. The plasticity of the Mo-10Ta alloy under the condition of SCJ forming was substantially enhanced compared with that under quasi-static deformation. The material grain was also refined under ultra-high strain rate, as reflected by the reduction in grain size from 232 μm to less than 10 μm.

Tungsten (W) fiber-reinforced tungsten (W_f/W) composite with ultra-high strength and high-temperature resistance is considered an attractive candidate material for plasma-facing materials (PFM) in future fusion reactors. The main component of W_f/W composite is tungsten wire, which is obtained through powder metallurgy and the drawing process. In this paper, high potassium (K)-doped tungsten wires with 98 ppm of K and 61 ppm of impurities are prepared using traditional and optimized processing technologies, respectively, and a comparative study with conventional K-doped tungsten wires with 83 ppm of K and 80 ppm of impurities is conducted. The high-temperature mechanical properties as well as the microstructure’s evolution of the prepared tungsten wires are investigated. The results show that the high-temperature performance of K-doped tungsten wires is improved by increasing the K content and by simultaneously reducing the impurities. By adopting small compression deformation and low-temperature processing technology, the high-temperature performance of high K-doped tungsten wires can be further improved. A microstructure analysis indicates that the excellent high-temperature performance is attributed to a combination of the small K bubble size, high K bubble number density, and long K bubble string, which are produced through optimization of the processing technology. A study on the processing technology and the performance of tungsten wires with a high K content and a high purity can provide important information regarding W_f/W composites.