Control of acidity is critical for cheese quality, as high acidity can be associated with poor flavor and textural attributes. We investigated an alternative method to control cheese acidity, specifically in low-fat (LF) and reduced-fat (RF) milled curd, direct-salted Gouda cheese, which involved altering the initial lactose content of cheesemilk. In traditional Gouda cheese manufacture, a critical technique to control acidity is whey dilution (WD); that is, partial removal of whey and its replacement with water. Direct standardization of the lactose content of milk during the ultrafiltration process could be a simpler and more effective technique to control cheese acidity. This study compared the effect of traditional WD at 2 different levels, 15 and 30% (WD15 and WD30), with the alternative approach of adjustment of the lactose content of milk using low-concentration-factor ultrafiltration (LCF-UF). The composition, texture, functionality, and sensory properties of these LF and RF Gouda cheeses were evaluated. A milled curd, direct-salted cheese manufacturing protocol was used. Milks used for cheesemaking had a lactose-to-casein (L:CN) ratio of approximately 1.8, which is the typical ratio found in milk, whereas milks prepared with lactose standardization (LS) were made from UF concentrated milks with water added during filtration to achieve a L:CN ratio of approximately 1.1. Cheeses made with LS exhibited lower lactose and lactic acid contents than WD30 and WD15, leading to significantly higher pH values in the cheese. Dynamic small-amplitude oscillatory rheology indicated that use of LS led to cheeses with a lower crossover temperature (melting point) than the cheeses made with WD. Cheeses made with LS had lower insoluble Ca contents, likely caused by the addition of water required to achieve the lower L:CN ratio in these milks. Sensory analysis also indicated that LS cheeses had lower acidity and softer texture. These results suggest that standardization of the L:CN ratio of milk could be a useful alternative to WD (or a curd rinse step) to reduce acidity in cheeses. In addition, LS could be used to help soften texture and increase meltability, if desired in lower-fat cheese types.
The objective of this study was to evaluate the effects of supplementation of dairy cows with different fatty acid sources (soybean oil (SO) and fish oil (FO)) on milk production, milk composition, milk fatty acid profile, and physicochemical and sensory characteristics of ice cream. During 63 days, fifteen Holstein cows averaging 198 ± 35 days in milk were assigned to three groups: control diet with no added lipid (n = 5 cows); and supplemented diets with SO (n = 5 cows; unrefined SO; 30 g/kg DM) or FO (n = 5 cows; FO from unrefined salmon oil; 30 g/kg DM). Milk production, milk fat, and milk protein were not affected by treatments. Saturated fatty acids in milk fat were decreased with SO and FO compared with control. C18:2 cis-9, cis-12 was increased with SO whereas C18:2 cis-9, trans-11, C20:3n-3, C20:3n-6, C20:5n-3, and C22:6n-3 were the highest with FO. Draw temperature and firmness were higher in SO compared to control and FO ice creams. Melting resistance was higher in FO compared with control and SO ice creams. Supplementation of cow diets with SO and FO did not have detrimental effects on milk production, or ice cream physicochemical and sensory characteristics.