The maximum capillary rise height of soil is a complex system which is mainly determined by the distribution characteristics of soil pores. The tests of the rising height of capillary water on 8 kinds of soils by the method of vertical tube are widely conducted to measure the maximum capillary rise height. Based on the BCC model and principles of thermodynamics, the soil‐water characteristic curve test is designed for the purpose of calculating the pore distribution of soil samples. A new method for calculating the maximum capillary rise height of soil is proposed by the author by using the distribution function of the soil pore. The coefficient β which reflects the relationship between the maximum capillary rise and the average pore radius of soils is utilized during the calculation process, and then the reference range of β for different soils is obtained according to series of experiments corresponding. The proposed calculation method offers an effective way to calculate the maximum capillary rise height, which can be applied to analyze the capillary effect area of relevant engineering problems.
4 August 2020 in Journal of Radioanalytical and Nuclear Chemistry
An improved electroosmotic method is proposed in this paper to enhance the non-uniform effect and efficiency of electroosmotic process. Such method is electroosmotic flow with injection of calcium chloride through the anode, followed by injection through the central tube (a tube at the midpoint between the anode and the cathode) with a suitable time interval between injections. Experimental results indicate that using this method can significantly improve the non-uniform reduction in water content throughout the soil, mitigate the formation of cracks in the anode section, and therefore considerably inhibit the increase in the electric resistance. After treatment, the drained water could be raised to 3.59 times more than that of pure electroosmotic flow, and 1.3 times that of simultaneous injection through both the anode and the central tube with considerably slight increase in power consumption. Moreover, the area of cementation was also expanded, approximately twice larger than that of pure electroosmotic flow and one and a half that of simultaneous injection. It is also worth noting that the proposed method performs better with the same power consumption. The results demonstrate that electroosmotic flow with a suitable time interval between injections could improve the efficiency of electroosmotic process and expand the treatment region in soils, hence can be a promising and economic technique for soil improvement in practical engineering.
Clayey sand is widely distributed and commonly encountered in geotechnical engineering practice. To understand its bearing capacity behavior under unsaturated conditions, plate load tests are performed on sand–kaolin mixture samples with varying water tables. The distributions of suction and volumetric water content with depth are measured by vibrating wire piezometers and soil moisture sensors, respectively. It is shown by the test results that the bearing capacity increases when the water table in the soil sample drops. The influence of suction on the bearing capacity is found to be dependent on the height of the water table and the hydraulic loading history of the soil sample. The plate load test results are interpreted using bearing capacity equations. Good agreement is obtained between measured and calculated bearing capacities. This study provides a simple method to estimate the bearing capacity of in situ unsaturated soil foundations.
Clay–gravel mixture has been widely used in high embankment dams and understanding its seepage characteristics is critical to dam safety. From the instrumental perspective, the realization of continuous pressurized water supply becomes a key technical challenge, significantly restricting the working conditions replicated in previous seepage apparatuses. To this end, a novel water provision system, relying on parallel-disposed sensor-based pressure devices, was introduced, so that the application of an existing large-scale stress-controlled apparatus can be expanded to long-term seepage tests regarding coarse-grained cohesive soils. Constant-head permeability tests were conducted on original-graded clay–gravel mixtures to investigate their hydraulic properties, incorporating the influence of stress relaxation. Test results show that with 35% gravel content, the clay–gravel mixture is suitable for dam construction as the core material. The stress relaxation holds a marginal effect on the hydraulic conductivity of soil. The functionality of this improved apparatus is verified, especially under long-term seepage conditions.