Clayey sand is widely distributed and commonly encountered in geotechnical engineering practice. To understand its bearing capacity behavior under unsaturated conditions, plate load tests are performed on sand–kaolin mixture samples with varying water tables. The distributions of suction and volumetric water content with depth are measured by vibrating wire piezometers and soil moisture sensors, respectively. It is shown by the test results that the bearing capacity increases when the water table in the soil sample drops. The influence of suction on the bearing capacity is found to be dependent on the height of the water table and the hydraulic loading history of the soil sample. The plate load test results are interpreted using bearing capacity equations. Good agreement is obtained between measured and calculated bearing capacities. This study provides a simple method to estimate the bearing capacity of in situ unsaturated soil foundations.
The limitations of conventional spot-sampling-based quality inspection in road construction can be effectively addressed by Intelligent Compaction (IC) technology. Acceleration signals acquired from the steel drums of vibratory rollers during the compaction process are widely used for real-time compaction monitoring. The signal-based evaluation framework is the core focus of the present work. First, fundamental mechanisms of vibratory compaction are elucidated. The theory of compaction energy transfer based on stress waves is further elaborated, thus establishing a theoretical foundation for compaction quality assessment based on acceleration signals. Second, a systematic overview of a dedicated signal processing workflow is presented, which comprises three sequential core procedures: signal acquisition, filtering, and time–frequency transformation. Third, Intelligent Compaction Measurement Values (ICMVs) derived from time-domain, frequency-domain, and time–frequency-domain analyses are classified, with their underlying calculation principles clarified. Finally, a comparative analysis of the predictive performance of three types of compaction control indicator prediction models, namely linear regression, traditional machine learning, and deep learning, is performed. Their applicable scenarios are evaluated. Meanwhile, the system architecture and core operational logic of an Internet of Things (IoT)-enabled IC system are introduced. Based on the above systematic analysis, prospective research directions are proposed, which are intended to provide theoretical references and technical guidance for the engineering application of IC technology.
18 September 2019 in IOP Conference Series: Earth and Environmental Science
The hydraulic servo control system of the ground motion parameter field test system is introduced in this paper. The hydraulic servo control system mainly includes the seismic wave generating equipment system and the servo control system. And the equipment system consists of the P-wave and the S-wave generator. The main advantage of the hydraulic servo control system is that P-wave and S-wave generator can generate both p-wave and S-wave. The seismic waves produced are characterized by strong stability and high energy, which can overcome the shortcomings of instability, less energy and poor repeatability of the on-site wave generating device. It is necessary to generate the waveform of different types of seismic waves, such as sine wave, cosine wave, square wave and random wave. The vibration frequency of the seismic wave can be controlled to meet the actual demand of the seismic wave in engineering. The hydraulic servo control system can be run stably for a long time, without interference and unreliable operation in various environments and states, which can be of great significance for the seismic safety evaluation of the engineering site.