In recent years, solar thermal energy (STE) has attracted energy researchers because of its higher efficacy compared to the photovoltaic solar cell. STE is one of the forms of solar energy whereby heat is transferred via a secondary medium called heat transfer fluids (HTFs). Therefore, the overall performance of STE depends on the thermophysical properties and thermal performance of the HTFs. Traditional HTFs suffer from low decomposition temperature, high melting point, and higher vapor pressure. To overcome these limitations, researchers have recently begun working on new HTFs for STE. Ionic liquids (ILs) are considered as a potential candidate for the next generation of HTFs because of their enhanced thermophysical properties, such as thermal stability at high temperature, insignificant vapor pressure, and high ionic conductivity. In addition, thermophysical properties and thermal performance of ILs can be further enhanced by dispersing nanoparticles, which is one of the emerging research interests to improve the efficiency of the solar thermal system. This paper summarizes the recent study of ILs-based nanofluids as HTFs. These summaries are divided into two sections (i) thermophysical properties studies, such as density, viscosity, thermal conductivity, and heat capacity, and (ii) thermal performance studies such as natural convection and forced convection. Synthesis of ILs-based nanofluids and thermophysical properties measurement techniques are also discussed. Based on these state-of-the-art summaries, we offer recommendations for potential future research direction for ILs-based nanofluids.
10 August 2023 in ASME Journal of Heat and Mass Transfer
In this paper, a novel sinusoidal wavy mini-channel heat sink (MCHS) with inter-connectors (IC w-MCHS) has been introduced, and the effectiveness of the proposed heat sink over conventional mini-channel heat sink (s-MCHS) has been numerically investigated. Different parameters, i.e., wavelengths, wave amplitudes, and phase shifts of the proposed sinusoidal wavy MCHS, were varied to study its effect on thermal and hydraulic performance. This study used three different wavelengths, three different amplitudes, and two different phase shifts, and Reynolds number (Re) varied from 300 to 800. The Nusselt number (Nu) of IC w-MCHS increased as the wave amplitude ratio (α) and Re increased, whereas it increased with the decrement of the wavelength ratio (β). Nu of the IC w-MCHS was also found to depend on phase shift (θp); for θp = π, the chaotic advection and increment of flow reversal were observed in the IC w-MCHS compared to θp = 0, resulting in higher Nu and higher pressure drop penalty. Nu of the IC w-MCHS was found to be 115% higher compared to s-MCHS at Re 550, θp = π,and a = 0.3,whereas it was found 77% higher for θp = 0. The maximum temperature of the IC w-MCHS heat sink was also found to decrease compared to that of the s-MCHS due to enhanced coolant mixing. A maximum26% decrease in the heat sink temperature was observed for the IC w-MCHS at Re 800 compared to the s-MCHS.