In this article, a mathematical model is developed to analyze piezoelectrically induced deformations of bistable smart beams with various geometric configurations and boundary conditions. The model delineates a straight beam bonded with a segmented piezoelectric material. Three types of support conditions are considered, namely, simple, clamped–clamped, and clamped–pinned supports. The beam is buckled into two possible stable curved shapes by means of edge shortening compression. A sudden change in transverse deflection from one to the other stable shape, so-called snap-through action, can be stimulated by electrical activation given to the piezoelectric material. The minimum potential energy principle associated with the modified Ritz method is used to predict developing shapes of the smart beam and the snap-through voltage. Principal minors of bordered Hessian matrix are calculated to determine the stability of the shapes obtained. Experiments were also conducted to corroborate the computational results in the case of the simply-supported smart beam. Comparisons between the two approaches reveal very good agreements in both mid-span displacements of buckled shapes and snap-through voltages. Finally, size and location of the segmented piezoelectric actuator are varied to search for the minimum critical electrical field for each support condition.
The transition toward sustainable transportation includes adopting ecofriendly electric vehicles in public transport, which reduces greenhouse gas emissions and increases energy efficiency. One of the critical features in fuel economy improvement of electric vehicles lies in lightweight structural design. Nevertheless, the crashworthiness of the structures of the vehicles and the safety of passengers must be guaranteed in the attempt of mass reduction because the crash of large vehicles such as buses usually costs many lives. This paper, therefore, aims to present an in-depth analysis of the impact behavior of a lightweight monocoque sandwich composite microbus body under full-frontal crash conditions. The bus structure, made of a high-density polyurethane foam core and woven glass fabric-epoxy face sheets, was modeled and simulated via LS-DYNA dynamic analysis using strength-based Chang-Chang criteria to characterize the failure mechanism of the structure and investigate intrusion into the passenger survival space. Under front collision, the front panel, A-pillars, and front sidewalls of the original bus were found to be extensively damaged in the compressive fiber mode. Based on the 50th percentile male dummy anthropometric parameters, injury indices of 0-5 intervals were proposed to evaluate occupant injury risks. The maximum front and side intrusion into the specified safety space under a maximum impact speed of 50 km/h is 208 mm at the front panel and 221 mm at the sidewall, indicating high injury indices of 3.59 and 4.81, respectively. The effects of stiffeners reinforced in the front panel and foam core thicknesses in the sidewalls, floor, and bottom parts on crashworthiness improvement were thoroughly discussed. The improved bus design can significantly enhance the safety of the occupants with a minimal increase in structural weight of merely 35.6 kg. An effective vehicle safety design under full frontal collision is presented.
15 April 2020 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
This paper proposes a novel design methodology for electric-bus structures by implementing the finite element method via ABAQUS™ and linear programming via MATLAB™. A monocoque sandwich-structured fiber-reinforced composite bus with a maximum driving range of 300 km is conceived using the proposed methodology. The bus-body structure is designed based on safety criteria such as vehicle registration regulations, the strength of the bus structure under various driving conditions, bending- and torsion-stiffness requirements, and the rollover testing standard of UN ECE R66. A procedure developed to systematically conduct parametric studies by varying the core and face thicknesses of the sandwich structure of each component is presented. Multivariate functions are formulated to determine the correlations of structural responses with changes in geometric parameters. Linear programming is implemented to minimize the mass of the bus structure under design constraints. The proposed monocoque bus structure meets all requirements, and its body mass is 63.3% less than the benchmark value.
23 June 2025 in International Journal of Mechanics and Materials in Design