The transition toward sustainable transportation includes adopting ecofriendly electric vehicles in public transport, which reduces greenhouse gas emissions and increases energy efficiency. One of the critical features in fuel economy improvement of electric vehicles lies in lightweight structural design. Nevertheless, the crashworthiness of the structures of the vehicles and the safety of passengers must be guaranteed in the attempt of mass reduction because the crash of large vehicles such as buses usually costs many lives. This paper, therefore, aims to present an in-depth analysis of the impact behavior of a lightweight monocoque sandwich composite microbus body under full-frontal crash conditions. The bus structure, made of a high-density polyurethane foam core and woven glass fabric-epoxy face sheets, was modeled and simulated via LS-DYNA dynamic analysis using strength-based Chang-Chang criteria to characterize the failure mechanism of the structure and investigate intrusion into the passenger survival space. Under front collision, the front panel, A-pillars, and front sidewalls of the original bus were found to be extensively damaged in the compressive fiber mode. Based on the 50th percentile male dummy anthropometric parameters, injury indices of 0-5 intervals were proposed to evaluate occupant injury risks. The maximum front and side intrusion into the specified safety space under a maximum impact speed of 50 km/h is 208 mm at the front panel and 221 mm at the sidewall, indicating high injury indices of 3.59 and 4.81, respectively. The effects of stiffeners reinforced in the front panel and foam core thicknesses in the sidewalls, floor, and bottom parts on crashworthiness improvement were thoroughly discussed. The improved bus design can significantly enhance the safety of the occupants with a minimal increase in structural weight of merely 35.6 kg. An effective vehicle safety design under full frontal collision is presented.
19 January 2024 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
An electric heavy quadricycle, categorized as an L7e vehicle, is an alternative solution for sustainable mobility with a lower carbon footprint and high energy consumption efficiency. However, accidental crashes of quadricycles with larger vehicle opponents can cause extensive damage to their structures and fatal injury to the occupants due to their geometry drawback in limited space in the front crumple zone. This work investigates the crashworthiness performance and safety assessment of the L7e vehicle under rigid wall crash tests and crash compatibility in car-to-car collisions with a sedan and an SUV. Crash scenarios are simulated using a nonlinear finite element analysis via LS-DYNA to evaluate structural crashworthiness and occupant injuries of a hybrid III 50th percentile male dummy. The compatible vertical alignment of the primary energy-absorbing structure substantially affects the safety of the quadricycle under a frontal crash. A secondary energy-absorbing component should be adapted to the L7e vehicle to achieve vertical alignment with different vehicle sizes. In addition, the typical rigid-wall frontal crash test at 50 kph considerably underestimates the structural damage and occupant injury of the L7e vehicle compared to car-to-car collisions. Thus, additional crash tests representing car-to-car collisions that account for the car’s smaller size and lighter mass should be included in the safety regulation for the L7e vehicle.
15 April 2020 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
This paper proposes a novel design methodology for electric-bus structures by implementing the finite element method via ABAQUS™ and linear programming via MATLAB™. A monocoque sandwich-structured fiber-reinforced composite bus with a maximum driving range of 300 km is conceived using the proposed methodology. The bus-body structure is designed based on safety criteria such as vehicle registration regulations, the strength of the bus structure under various driving conditions, bending- and torsion-stiffness requirements, and the rollover testing standard of UN ECE R66. A procedure developed to systematically conduct parametric studies by varying the core and face thicknesses of the sandwich structure of each component is presented. Multivariate functions are formulated to determine the correlations of structural responses with changes in geometric parameters. Linear programming is implemented to minimize the mass of the bus structure under design constraints. The proposed monocoque bus structure meets all requirements, and its body mass is 63.3% less than the benchmark value.
1 January 2023 in Latin American Journal of Solids and Structures