In Poland the use of solid biomass obtained from intentional plantations of energy plants is increasing. This biomass is most often processed into solid fuels. There are growing indications that renewable energy sources, in particular biomass production, will continue to develop, so the better we know the raw material, the more effectively we will be able to use it. The results of tests that determine the impact of compaction pressure on selected quality parameters of pellets made from selected biomass types are presented. Material from plants such as Giant miscanthus (Miscanthus × giganteus Greef et Deu), Cup plant (Silphium perfoliatum L.), Virginia mallow (Sida hermaphrodita (L.) Rusby) was studied. The compaction process was carried out using the SIRIO P400 hydraulic press with a closed chamber with a diameter of 12 mm. Samples were made in four pressures: 131; 196; 262; 327 MPa and three moisture levels: 8%, 11%, 14%. It was found that with increasing compaction pressure and moisture content up to a certain point, the density and durability of the pellets also increased. Each of the materials is characterized by a specific course of changes in the parameters tested.

Increasing production of waste has compelled the development of modern technologies for waste management. Certain fractions of municipal solid wastes are not suitable for recycling and must be utilised in other ways. Materials such as refuse-derived fuel (RDF) fractions are used as fuel in cement or CHP (combined heat and power) plants. The low bulk density leads to many problems pertaining to transportation and storage. In the case of biomass, these problems cause reduction in pelletisation. This paper therefore presents a comprehensive study on RDF pellet production, which is divided into three major areas. The first describes laboratory-scale tests and provides information on key factors that affect pellet quality (e.g., density and durability). Based on this, the second part presents a design of modified RDF dies to form RDF pellets, which are then tested via a semi-professional line test. The results show that RDF fraction can be compacted to form pellets using conventional devices. Given that temperature plays a key role, a special die must be used, and this ensures that the produced pellets exhibit high durability and bulk density, similar to biomass pellets.

The paper presents the results of research, the objective of which was to determine the impact of particle size distribution and density of digestates and ash on density and tensile strength of granular fertilizer obtained from mixtures of these substrates. Particle size distribution, absolute density, envelope density and porosity of substrates were determined. Granular fertilizers were made of clean substrates and their mixtures. Envelope density of the obtained granulates was within 0.81 - 1.88 g⋅cm^-3. The determined compaction degree was within 3.65 - 10.12. While, the compaction index IS of granulates made of mixtures was within 0.5 - 0.55 and was lower in comparison to IS of granulates from digestates (0.6) and ash (0.76).