During isolation, exopolysaccharides (EPS) from lactic acid bacteria are subject of thermal, chemical, enzymatic or ultrasound stress of different intensity that may affect macromolecular properties, for instance molecular mass or (intrinsic) viscosity. These parameters are, however, crucial, as they are associated with the technofunctional potential of EPS replacing commercial thickeners in nonfermented products. The aim of this study was to systematically examine treatments EPS are usually exposed to during isolation and to investigate the underlying degradation mechanisms. Solutions (1.0 g/L) of EPS from Streptococcus thermophilus, isolated as gently as possible, and commercial dextran were analyzed for molecular mass distributions as representative measure of molecule alterations. Generally, acid, excessive heat and ultrasonication, intensified by simultaneous application, showed EPS degradation effects. Thus, recommendations are given for isolation protocols. Ultrasonic degradation at 114 W/cm² fitted into the random chain scission model and followed third- (S. thermophilus EPS) or second-order kinetics (dextran). The degradation rate constant reflects the sensitivity to external stresses and was DGCC7710 EPS > DGCC7919 EPS > dextran > ST143 EPS. Due to their exceptional structural heterogeneity, the differences could not be linked to individual features. The resulting molecular mass showed good correlation (r² = 0.99) with dynamic viscosity.
Some lactic acid bacteria are able to produce exopolysaccharides that, based on localization, can be distinguished in free and capsular or cell-bound exopolysaccharides (CPS). Up to now, the former were the focus of current research, mainly because of the technofunctional benefits they exhibit on fermented dairy products. On the other hand, CPS affect the surface properties of bacteria cells and thus also the textural properties of fermented foods, but data are very scarce. As the cell surface properties are strongly strain dependent, we present a new approach to investigate the impact of CPS on cell surface hydrophobicity and moisture load. CPS positive and negative Streptococcus thermophilus and Weissella cibaria were subjected to ultrasonication suitable to detach CPS without cell damage. The success of the method was verified by scanning electron and light microscopy as well as by cultivation experiments. Before applying ultrasonication cells with CPS exhibiting an increased hydrophilic character, enhanced moisture load, and faster water adsorption compared to the cells after CPS removal, emphasizing the importance of CPS on the textural properties of fermented products. The ultrasonic treatment did not alter the cell surface properties of the CPS negative strains.
1 July 2023 in International Journal of Biological Macromolecules
Exopolysaccharides (EPS) from Streptococcus thermophilus provide similar technofunctionality such as water binding, viscosity enhancing and emulsifying effects as commercial thickeners at a significant lower concentration. Despite their high technofunctional potential, hetero polysaccharides from lactic acid bacteria are still not commercially used in unfermented foods, as the small amount of synthesised EPS calls for a high isolation effort. This study aims to analyse the macromolecular properties of EPS and cell containing isolates from S. thermophilus DGCC7710 obtained by different isolation protocols, and to link these data to the technofunctionality in model food systems. The EPS content of the isolates was affected by the microfiltration/ultrafiltration membranes used for cell removal/dialysis, respectively, and was 89% at maximum. There was no link between purity of the isolates, molecular mass (3 × 106 Da) and intrinsic viscosity (0.53 – 0.59 mL/mg) of the EPS. After adding EPS containing isolates to milk, gel stiffness after acidification increased by 25% at maximum, depending on the type and concentration of the specific isolate. Partly purified, cell containing isolates were effective at low absolute EPS concentration (approx. 0.1 g/kg) and therefore represent, together with their simple isolation protocol, an interesting approach to introduce microbial EPS into non‐fermented products.