Zhanguo XIU

Dr. Zhanguo XIU


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 December 2019 in Bulletin of Engineering Geology and the Environment
Verified
Journal Article
Closed access
PDF file
ZXZhanguo XIU
Zhanguo XIU
SWShu-hong Wang
Shu-hong Wang
YJYingchun Ji
Yingchun Ji
Feili WangFeili Wang
Feili Wang
FRFengyu Ren
Fengyu Ren

29 December 2020 in Applied Sciences
Verified
Journal Article
Open access
PDF file
Feili WangFeili Wang
Feili Wang
SWShu-hong Wang
Shu-hong Wang
ZXZhanguo XIU
Zhanguo XIU
The dynamic damage of cracked rock threatens the stability of rock structures in rock engineering applications such as underground excavation, mineral exploration and rock slopes. In this study, the dynamic damage of cracked rock with different spatial geometry was investigated in an experimental method. Approximately 54 sandstone specimens with different numbers of joints and different filling materials were tested using the split Hopkinson pressure bar (SHPB) apparatus. The energy absorption in this process was analyzed, and the damage variable was obtained. The experimental results revealed that the dynamic damage of cracked rock is obviously influenced by the number of cracks; the larger the number, the higher the energy absorption and the bigger the dynamic damage variable. Moreover, it was observed from the dynamic compressive experiments that the energy absorption and the dynamic variable decreased with the strength and cohesion of the filling material, indicating that the filling material of crack has considerate influence on the dynamic damage of cracked rock.

27 April 2022 in Lithosphere
Verified
Journal Article
Open access
PDF file
Feili WangFeili Wang
Feili Wang
Bangbiao WuBangbiao Wu
Bangbiao Wu
SWShuhong Wang
Shuhong Wang
FMFanZheng Meng
FanZheng Meng
ZXZhanguo XIU
Zhanguo XIU
CWChonglang Wang
Chonglang Wang
The presence of discontinuities can significantly weaken rock masses, whose shear load-bearing capacity is always dictated by discontinuity failures. The shear response of rock discontinuity has been extensively studied under low loading rate conditions, while the effect of impact loading on its shear strength was unclear. To address this issue, rock discontinuity samples with quantified surface roughness were tested under six normal stresses (0%, 5%, 10%, 15%, 20%, and 25% of its uniaxial compressive strength) and different loading rates (varying from 100 MPa/ms to 700 MPa/ms) by a novel-designed impact shear testing system. Experimental results show that the impact shear strength is proportional to the loading rate and exhibits significant rate dependence. Moreover, the cohesion is clearly rate-dependent and the friction angle keeps constant during impact loading, which shows obviously different behaviors with those under static loading conditions. Considering the rate effect of the shear strength parameters, the shear strength criterion of rough rock discontinuity under impact loading was established. Furthermore, a statistical constitutive model was proposed by incorporating the Weibull distribution of the shear damage. The successful application of the theoretical model to the experimental data shows that the proposed models can well predict the shear strength and describe the shear damage of rough rock discontinuities under impact loading.

12 November 2019 in Geofluids
Verified
Journal Article
Open access
SWShu-hong Wang
Shu-hong Wang
Feili WangFeili Wang
Feili Wang
ZXZhanguo XIU
Zhanguo XIU
Shear strength deterioration of rock joints and its induced instability of key blocks subjected to dynamic disturbance constitute the mechanism of many geological disasters such as rockburst, landslide, and rockfall. In this study, the influence of dynamic disturbance on rock joints was quantified in the form of stress, of which model was established by quasistatic method. The dynamic shear strength of rock joints was analyzed theoretically following the Coulomb-Navier criterion and further investigated experimentally by split Hopkinson pressure bar (SHPB) tests with impact velocities of 4.850 m/s, 8.722 m/s, 12.784 m/s, and 16.935 m/s. The effect of engineering disturbance on shear strength of rock joints was measured, and a degradation coefficient was used to describe it quantitatively. Considering the degradation of dynamic shear strength of rock joints and its influence on block stability, the method for determining key blocks under dynamic disturbance was given. Implementing this method into the program of Geotechnical Structure and Model Analysis-3D (GeoSMA-3D) developed by the authors’ team, the visualization of key blocks was achieved. From theoretical analysis and experimental investigation, it was figured out that the shear strength of rock joints is degraded under dynamic disturbance. The degradation of friction angle becomes more sensitive than that of cohesion. Additionally, numerical results show that the number of key blocks was increased with the increasing impact velocities.

23 May 2019 in KSCE Journal of Civil Engineering
Verified
Journal Article
Open access
PDF file
CLChun Li
Chun Li
ZXZhanguo XIU
Zhanguo XIU
YJYingchun Ji
Yingchun Ji
Feili WangFeili Wang
Feili Wang
ACA. H. C. Chan
A. H. C. Chan
The generalized plasticity theory has been subject of much research in geomechanics. The Pastor-Zienkiewicz model and its modified versions are among these. For large foundations resting on multilayered soils the actual loading is often non-linear. In this study we developed a new mathematical model which can apply non-linear loading using the subfield of planar mesh method. A sensitivity study was first performed to evaluate the contribution of deformation from various model parameters. It is found that the plastic modulus parameters only have marginal contributions. An engineering case study was used to valid the proposed model and it is evident from measured stresses that the loading of the foundation is non-linear. The deformations calculated by the proposed model agreed well with the monitored deformations. It is also found that the maximum deformation point is not necessarily in the centre of foundation and it does not coincide with the maximum loading point either. The distance between the maximum deformation point and the maximum loading point can be as far as 15.59 m for the bottom layer soil from this case. This research proves the necessity of using non-linear loading to calculate the foundation deformations for large foundations with multilayered saturated soils.