ZnO nanoparticle reinforced polytetrafluoroethylene/polyimide (PTFE/PI) nanocomposites were prepared and their corresponding tribological and mechanical properties were studied in this work. The influences of ZnO loading, sliding load, and velocity on the tribological properties of ZnO/PTFE/PI nanocomposites were systematically investigated. Results reveal that nanocomposites reinforced with 3 wt% ZnO exhibit the optimal tribological and mechanical properties. Specifically, the wear loss decreased by 20% after incorporating 3 wt% ZnO compared to unfilled PTFE/PI. Meanwhile, the impact strength, tensile strength, and elongation‐at‐break of 3 wt% ZnO/PTFE/PI nanocomposite are enhanced by 85, 5, and 10% compared to pure PTFE/PI blend. Microstructure investigation reveals that ZnO nanoparticles facilitate the formation of continuous, uniform, and smooth transfer film and thus reduce the adhesive wear of PTFE/PI.
NaCl particles were added into Polyetheretherketone (PEEK) and its composites to produce porous PEEK-based materials by washing NaCl away after the high-temperature compression molding process. After that, an ionic liquid was added into the porous materials under vacuum condition. Carbon fibers (CF), as reinforcement, and PTFE, as an internal solid lubricant, were employed to prepare PEEK composites. Tribological properties under dry friction condition were studied on a ring-on-disc tribo-meter. The influence of CF and PTFE on tribological properties was carefully investigated. The results indicated that, in comparison with traditional PEEK composites (CF/PTFE/PEEK), the porous PEEK composites containing ionic liquid showed much better tribological properties. It is found that CF can help PEEK form effective pores to suck in the ionic liquid resulting in a better tribological performance. CF reinforced porous PEEK containing ionic liquid (p-CF/PEEK + IL) demonstrated the lowest friction coefficient (27% of CF/PTFE/PEEK) and the lowest wear loss (only 0.9% of CF/PTFE/PEEK). Long time tribological test revealed that the wear mass loss comes from the running-in period, while its wear is negligible after this period. It is also found that the addition of PTFE has a negative influence on the tribological behaviors, especially under high sliding velocity and applied load.
16 June 2014 in Macromolecular Chemistry and Physics