Fundamentals of quantum dots (QDs) sensing phenomena show the predominance of these fluorophores over standard organic dyes, mainly because of their unique optical properties such as sharp and tunable emission spectra, high emission quantum yield and broad absorption. Moreover, they also indicate no photo bleaching and can be also grown as no blinking emitters. Due to these properties, QDs may be used e.g., for multiplex testing of the analyte by simultaneously detecting multiple or very weak signals. Physico-chemical mechanisms used for analyte detection, like analyte stimulated QDs aggregation, nonradiative Förster resonance energy transfer (FRET) exhibit a number of QDs, which can be applied in sensors. Quantum dots-based sensors find use in the detection of ions, organic compounds (e.g., proteins, sugars, volatile substances) as well as bacteria and viruses.

The results presented in this paper show how the optical properties and colloidal stability of quantum dots (QDs) vary depending on pH conditions. For this investigation, as-synthesized hydrophobic CdSe/CdS QDs were transferred to an aqueous medium by surface modification with 3-mercaptopropionic acid. The ligand exchange procedure was applied under three different pH conditions: acidic, neutral and alkaline, to obtain three kinds of hydrophilic QDs dispersed in phosphate buffer. The efficiency of the functionalization of QDs was estimated based on the changes in ABS and the highest value was obtained under acidic conditions (45%). The efficiency of photoluminescence (PL) was also best preserved under these conditions, although it was 30 times less than the PL of hydrophobic QDs. Then, all three kinds of hydrophilic QDs were dispersed in solutions with a wide range of pH (2–12) and investigated by absorbance and PL measurements. The results show that QDs subjected to a ligand exchange procedure are characterized by intensive PL at the selected pH values, which correspond to pK_a of the ligand. This phenomenon is independent of the pH at which the ligand exchange procedure is conducted. Moreover, it was found that the PL intensity is preserved during the experiment for QDs functionalized under neutral conditions, whereas it decreases for acidic and increases for alkaline conditions.

We proposed to exploit phosphomolybdic acid (PMA) as a cost-efficient MoO _x source for combined spin-coating/sputtering/spin-coating deposition of a MoO _x /Au/MoO _x (MAM) composite electrode.

The influence of precursor composition on the crystallization of Li_xNa_1−xGdF₄ is investigated and discussed. Nanocrystals are prepared from the thermal decomposition of trifluoroacetates in the presence of trioctylphosphine oxide to provide control over particle size. A crystal phase transition from hexagonal to cubic and to tetragonal is observed by increasing lithium trifluoroacetate (Li-TFA) in the solution. Controlling the composition of Li_xNa_1−xGdF₄ nanocrystals results in modified crystal field symmetry and emission properties from doped europium (Eu³⁺) ions. We report that for lithium (Li⁺) substitution <15%, the hexagonal crystal field is preferred, while the Eu³⁺ emission is already tuned, whereas at higher Li⁺ substitution, a phase change takes place and the number of crystalline matrix defects increases which is reflected in the optical properties of Eu³⁺. From Eu³⁺ emission properties, the optimum Li⁺ content is determined to be ∼6.2% in the prepared Li_xNa_1−xGdF₄ nanocrystals.

In this study, the role of a zinc acetate precursor in improving the luminescence stability of purple-emitting CdS nanocrystals is investigated. The oleate-capped core of CdS nanocrystals exhibits intense photodarkening under prolonged UV excitation. From the results of photoluminescence experiments, we can observe that photobleaching is responsible for the degradation of temporal stability, i.e., decline in photoluminescence intensity. Herein, we demonstrate that by adding zinc acetate to the synthesis solution, one can enhance the photoluminescence stability by the complete suppression of the bleaching processes of nanocrystals. We can distinguish between the effects caused by zinc ions and those caused by acetate ligands. Acetate ligands improve the photoluminescence stability of the core of CdS nanocrystals. However, only when zinc acetate is used, the PL stability can be conserved at high excitation power. Simultaneously, we have studied the influence of zinc cations and acetate ligands on the kinetics of nanocrystal growth. The presented results underline the importance of short surface capping ligands and zinc cations in CdS nanocrystal synthesis. This study exhibits a new advantage of exploiting zinc acetate reagents in one-pot nanocrystal synthesis.