Experiments have recently demonstrated that kinetic instabilities occurring in magnetoplasma are huge limiting factors to the flux of highly charged ion beams extracted from ECR ion sources. Recently, it has been shown that the two-frequency-heating (TFH) mode has the proven potential to mitigate these instabilities. Since the fundamental physical mechanism of TFH is still unclear, a deeper experimental investigation is necessary. At ATOMKI-Debrecen, the effect on the kinetic instabilities of an argon plasma in a ‘two-close-frequency heating’ scheme has been explored for the first time by using a frequency gap smaller than 1 GHz (i.e. operating in the so-called two-closed-frequency heating mode). A special multi-diagnostics setup has been designed and implemented. In this paper, we will show the data collected by a two-pin, plasma-chamber immersed antenna connected to an RF detector diode and/or to a spectrum analyzer for the detection of plasma radio-self-emission when varying the pumping frequency in single versus double frequency heating mode. Data have been collected simultaneously to the beam extraction and for different frequency gaps and relative power balances. The turbulent regime of the plasma has been tentatively described in a quantitative way, according to the properties of the plasma self-emitted RF spectrum. The measurements show that plasma self-emitted radiation emerges from the internal ECR region everytime (i.e. below the lower pumping frequency) but the almost total instability damping can be effective for some specific combinations of frequency-gap and power balance, thus eventually improving the plasma confinement.

An experimental campaign aiming to investigate electron cyclotron resonance (ECR) plasma X-ray emission has been recently carried out at the ECRISs—Electron Cyclotron Resonance Ion Sources laboratory of Atomki based on a collaboration between the Debrecen and Catania ECR teams. In a first series, the X-ray spectroscopy was performed through silicon drift detectors and high purity germanium detectors, characterizing the volumetric plasma emission. The on-purpose developed collimation system was suitable for direct plasma density evaluation, performed “on-line” during beam extraction and charge state distribution characterization. A campaign for correlating the plasma density and temperature with the output charge states and the beam intensity for different pumping wave frequencies, different magnetic field profiles, and single-gas/gas-mixing configurations was carried out. The results reveal a surprisingly very good agreement between warm-electron density fluctuations, output beam currents, and the calculated electromagnetic modal density of the plasma chamber. A charge-coupled device camera coupled to a small pin-hole allowing X-ray imaging was installed and numerous X-ray photos were taken in order to study the peculiarities of the ECRIS plasma structure.

Pinhole and CCD based quasi-optical x-ray imaging technique was applied to investigate the plasma of an electron cyclotron resonance ion source (ECRIS). Spectrally integrated and energy resolved images were taken from an axial perspective. The comparison of integrated images taken of argon plasma highlights the structural changes affected by some ECRIS setting parameters, like strength of the axial magnetic confinement, RF frequency and microwave power. Photon counting analysis gives precise intensity distribution of the x-ray emitted by the argon plasma and by the plasma chamber walls. This advanced technique points out that the spatial positions of the electron losses are strongly determined by the kinetic energy of the electrons themselves to be lost and also shows evidences how strongly the plasma distribution is affected by slight changes in the RF frequency.

Electron cyclotron resonance ion sources (ECRIS) are widely used plasma based machines for the production of intense ion beams in science and industry. The performance of modern devices is limited by the presence of the density cut-off, above which electromagnetic (EM) waves sustaining the plasma are reflected. We hereby discuss the systematic data analysis of electrostatic wave generation in an ECR prototype operating at 3.75 GHz–0.1 THz. In particular, electron Bernstein waves (EBW) have been excited. EBW have already been generated in large-scale plasma devices for thermonuclear fusion purposes. In ion sources where L _c ∼ λ _RF ( L _c being the plasma chamber size and λ _RF the pumping wave wavelength) the EM field assumes a modal behaviour; thus both plasma and EM field self-organize so that no optical-like wave launching is possible (i.e. the cavity effect dominates on the optical path). The collected data, however, supported by 3D full-wave simulations, actually demonstrate that a Budden-type X-B conversion scenario can be established above some critical RF power thresholds, operating in an off-ECR regime. The generation and absorption of the EBW has been demonstrated by the presence of three peculiar signatures: along with the establishment of an overdense plasma, generation of supra-thermal electrons and modification (non-linear broadening) of the EM spectrum measured within the plasma have been observed. At the threshold establishing such a heating regime, the collected data provide evidence for a fast rotation of the electron fluid.