Additive manufacturing (AM) represents the present and the future of manufacturing production, thanks to a new design paradigm that allows the customization of components based on the needs of the final application, all framed in a perspective of sustainable and on-demand production. It has become an increasingly popular method for manufacturing complex and custom parts, especially those made from metallic materials, such as AISI 316L. AISI 316L is a type of austenitic steel widely used in industries such as aerospace, medical, automotive, and marine due to its excellent corrosion resistance and high strength. Thanks to its physico-chemical properties, AISI 316L stainless steel is one of the most used metals for AM. In this paper, a critical review of printing technologies, microstructural defects, mechanical properties, as well as industrial applications of AISI 316L are presented based on the state of the art. Furthermore, the main challenges with AM AISI 316L techniques are discussed, such as the influence of printing parameters, surface quality, and other common problems identified in the literature. Overall, this paper provides a comprehensive overview of AISI 316L AM techniques, challenges, and future research directions.
1 April 2019 in Materials Science and Engineering: A
The purpose of this paper is to investigate the variation in the coefficient of friction (CoF) and also the wear in a lead bronze coating under different texture conditions. The tribological tests were performed using a tribometer with pin on disk configuration. Several kinds of textures, realised by a surface laser texturing, were tested by varying the diameter, depth, and density of the dimples under severe working conditions. The innovative aspect concerns the behaviour of the textured lead bronze coating and the lubrication conditions when the sample is subjected to extreme load conditions. Confocal microscopies and SEM (Scanning Electron Microscopy)/EDS (Energy Dispersive X-Ray Spectroscopy) analyses were performed to evaluate the texture behaviour and also the surface deterioration of the coating. The results show that the application of texture processing leads to an improvement in the tribological properties of the coating. By analysing separately the variation of the different geometric parameters of the dimples, it has been shown that the best results are obtained with a diameter of 50 μm, a density of 5%, and a depth of 5 μm.
Titanium dental implants have had new competitors in recent years, such as fixtures made of zirconia, which promise better aesthetics. The purpose of this study is to evaluate their mechanical performance in silico (Finite Element Analysis). The investigation was performed on a single tooth Patent™ Dental Implant (Zircon Medical®, Altendorf, Switzerland) in two configurations: without offset (Test I) and with offset (Test II, 1.5 mm within the cortical bone). The Patent Implant system consists of two components: the implant with integrated abutment and the fibreglass post. The components of the dental implants were tested using a compression load of 400 N along the implant axis. The results showed that the chewing load generates stress distribution on the bone, therefore, the offset configuration should be avoided.
24 October 2022 in Fatigue & Fracture of Engineering Materials & Structures
The aim of the present work is to investigate the difference in mechanical behavior between AISI 316L obtained by the turning process and that obtained by selective laser melting (SLM). To obtain a correlation between mechanical behavior and microstructure, static tensile and fatigue tests were performed, monitoring the energy release of the material adopting, respectively, the static thermographic method (STM) and the Risitano's thermographic method (RTM). Failure analysis was performed using optical and scanning electron microscopy. The corrosion resistance was evaluated by the double‐loop electropotential reactivation (DL‐EPR). Worst mechanical properties, both under static and fatigue loading conditions, loss of corrosion resistance, and heat dissipation compared to traditional stainless steel have been found. These findings can be attributed to microstructural defects typical of the SLM printing technology.