Successful mapping of concrete crosstie flexural demands to different railroad track support conditions can lead to an improved understanding of crosstie flexural performance and more representative design requirements. Even though the ballast layer typically provides significant pressure distribution variability under concrete crossties, understanding these support conditions is essential for accurately predicting bending moments along the crossties, a useful metric for both design and planning of tamping activities in railroad track. To quantify the influence of support conditions on concrete crossties’ bending moments, laboratory experiments were performed. New and center-cracked concrete crossties were loaded while subjected to different support conditions through the use of rubber pads designed to simulate the ballast support. Results show that bending moments at the crosstie center are quite sensitive and may even be underestimated in current U.S. design practices that do not currently allow for cracking. Additionally, findings indicate that rail seat bending moments may be overestimated in typical design practices. Finally, there was no statistically significant difference between bending moments of uncracked and cracked crossties for the investigated cracking pattern.
10 March 2023 in Transportation Research Record: Journal of the Transportation Research Board
Longitudinal track resistance is one of the most critical parameters required to accurately analyze longitudinal load propagation and refine rail neutral temperature (i.e., stress-free temperature) maintenance practices. However, longitudinal track resistance has not been consistently defined and has been quantified using multiple methods that should not be conflated. This paper documents common definitions of longitudinal track resistance and the two methods regularly used for its quantification: track panel pull test (TPPT) and single rail break (SRB). Further, this paper documents the differences in mechanics between these methods, summarizes and discusses the critical factors influencing the longitudinal track resistance values found in the literature, and adds novel TPPT longitudinal track resistance values for timber sleeper track to address the current scarcity of data found in the literature. In summary, TPPT values provide insight into the mechanics of load propagation and pre-buckle analysis while the SRB values aid in the maintenance and restoration of rail neutral temperature after a rail break or destress. Additionally, the TPPT longitudinal track resistance values reported in the literature were independent of panel length, were influenced most by the presence of a vertical load, and were reduced by 25% when the ballast was disturbed. Finally, novel TPPT results indicated the longitudinal resistance of timber sleeper track was 19% lower than concrete sleeper track and that unfastened sleepers still transferred longitudinal load when the cribs were full and ballast was compacted.
1 March 2018 in Journal of Transportation Engineering, Part A: Systems
With use of concrete sleepers increasing for rail-transit applications in the United States, it is becoming more critical to quantify their revenue service flexural demands to improve sleeper design and maintenance practices. Rail-transit concrete sleeper bending moment field data were collected and processed to address topic areas relating to (1) overall field bending moment magnitude relative to design moments; (2) moment variation from sleeper to sleeper resulting from support conditions; and (3) seasonal variations in moments. Data from field locations on light and heavy rail-transit properties show levels of reserve flexural capacity (factors of safety) that reach as high as 6, significant sleeper-to-sleeper variability attributable to support conditions that can be as high as 100%, and seasonal variation in bending moments that is measurable but far lower than daily variability caused by temperature by a factor of 2. These data provide a valuable baseline for the future generation of mechanistic design standards for track infrastructure components.