Using the forced oscillation method and the ultrasonic transmission method, we measure the elastic moduli of a clay‐bearing Thüringen sandstone under dry and water‐saturated conditions in a broad frequency band at [0.004–10, 106] Hz for different differential pressures up to 30 MPa. Under water‐saturated condition, clear dispersion and attenuation for Young's modulus, Poisson's ratio, and Bulk modulus are observed at seismic frequencies, except for shear modulus. The measured dispersion and attenuation are mainly attributed to the drained/undrained transition, which considers the experimentally undrained boundary condition. Gassmann's predictions are consistent with the measured undrained bulk moduli but not with the shear moduli. Clear shear weakening is observed, and this water‐softening effect is stronger at seismic frequencies than at ultrasonic frequencies where stiffening effect related to squirt flow may mask real shear weakening. The reduction in surface free energy due to chemical interaction between pore fluid and rock frame, which is not taken into account by Gassmann's theory, is the main reason for the departure from Gassmann's predictions, especially for this rock containing a large number of clay minerals.
22 January 2019 in Rock Mechanics and Rock Engineering
Elastic properties and fracture behaviour evolutions of two sedimentary stones are under study to estimate their influence on scaling effect of monumental stone heritage. Young moduli and toughness of Villarlod molasse and Thüringer sandstone are measured under moisture content variations with respect to their natural anisotropy. Several relative humidity levels are considered to investigate their effect upon humidification and drying. The stone property evolution is in close correlation with the identified clay phases of the matrix. It appears that clay minerals as smectite and glauconite influence the stone properties at very low moisture contents, whereas less swelling clays have impact only when high moisture contents are reached. This is in close correlation with the inherent deformation ability of these minerals. It is observed that nature and distribution of clay phases largely influence on the macroscopic behaviour under natural exposure conditions, as they modify the stone properties and represent the weakness planes of the stone.
15 July 2017 in Rock Mechanics and Rock Engineering
Both an experimental and a theoretical investigation of fracture propagation mechanisms acting at the process zone scale in glassy polymers are presented. The main aim is to establish a common modeling for different kinds of glassy polymers presenting either steady-state fracture propagation or stick-slip fracture propagation or both, depending on loading conditions and sample shapes. From the experimental point of view, new insights are provided by the in situ AFM measurements of viscoplastic strain fields acting within the micrometric process zone in a brittle epoxy resin, which highlight an extremely slow unexpected steady-state regime with finite plastic strains of about 30% around a blunt crack tip, accompanied by propagating shear lips. From the theoretical point of view, we apply to glassy polymers some recently developed models for describing soft dissipative fracture that are pertinent with the observed finite strains. We propose a unified modeling of fracture energy for both the steady-state and stick-slip fracture propagation based on the evaluation of energy dissipation density at a characteristic strain rate induced in the process zone by a competition between the crack propagation velocity and the macroscopic sample loading rate.
In this investigation on the mechanical behaviour of paint films, we use a new ferrule-top nanoindentation protocol developed for cultural heritage studies to examine the impact of repeated relative humidity variations on the viscoelastic behaviour of paint films and their mechanical properties in different paint stratigraphies through the changes in their storage and loss moduli. We show that the moisture weathering impact on the micromechanics varies for each of these pigment-oil systems. Data from the nanoindentation protocol provide new insights into the evolution of the viscoelastic properties dsue to the impact of moisture weathering on paint films.
Preservation of cuneiform tablets made with clay minerals is an ongoing conservation issue. A treatment based on TEOS consolidation has been used since 1996 at the Louvre museum. The characterization of the tablets pointed out kaolinite, illite, and smectite as the three main clay minerals constituting the objects. In this research, the physico-mechanical aspects of the treatment are investigated. The penetration depth of the TEOS solution and the gradient induced are quantified using laboratory samples. TEOS treatment preserves the macroscopic swelling and the vapour transfer properties, but modifies the clay’s affinity to moisture. Elastic properties are gradually improved for all clays, but only kaolinite’s strength increases significantly. The impact of TEOS treatment on the natural behaviour related to the respective structure of the clays is considered, and the amount of kaolinite required to create adequate reactions appears to be of interest for conservation treatments.