One of the main cause of damages for wind turbine power plants is certainly constituted by lightning. Direct and indirect events can indeed produce damages and malfunctions of electrical and mechanical components. Concerning mechanical components, blades and bearings are the most involved parts. In particular, lightning-damages produced at bearings positioned at the mechanical interface between rotating parts of the wind turbine, can result in high costs, considering the difficulties involved in the replacement of such components. The paper presents a numerical and an analytical model of wind turbine main shaft bearings aimed at calculate their electrical impedance along with their experimental validation. These models provide useful criteria for the design of wind turbines lightning protection systems (LPS). In this respect, the paper presents also the development of a specific LPS for the protection of wind turbine bearings and the relevant effectiveness analysis obtained by means of experimental tests.
4 December 2009 in Electric Power Systems Research
In the present paper data collected from the field related to the damage statistics of electrical and electronic systems due to lightning overvoltages are reported. These damages were registered by German insurance companies in 2005 and 2006 in different structures and installations. With the use of stochastical methods it is possible to reassess the collected data and to define cases, which are with high probability caused by lightning overvoltages. The results of the stochastic model are compared with the probability of damage distributions obtained by using the analytical method, which is the basis for the IEC Standard rules.
The paper deals with a simplified approach to evaluate the frequency of damage of low voltage apparatus powered by a in housing HV/LV transformer against overvoltages due to nearby lightning flashes (source of damage S4 according to IEC 62,305 standard). The approach is based on computer simulations with validated models according to the current state of the art. The paper evaluates: the overvoltages stressing the HV/LV transformer due to lightning-induced over-voltages on the supplying HV overhead line; the voltage transferred to low voltage circuit through the power transformer and the influence of the transformer characteristics and of the LV circuits feeding the apparatus; the influence of the characteristics and the number of LV circuits on the frequency of damage of the apparatus. The different contributions to the voltage at the apparatus terminals, namely, the voltage transferred by the HV/LV transformer and the voltage induced by lightning current in the circuit downstream the transformer, are recognized. The voltage drop along the earthing system between the points where the transformer and the apparatus are earthed is, in the case considered, not effective because the apparatus and the transformer are bonded at the same point to the earthing system of the electrical installation. Even if these voltage components exhibit different shape and time at peak, for safety, they are added. When the resulting voltage is higher than the rated impulse voltage of apparatus insulation, damage of apparatus occurs. The evaluation allows to conclude that the frequency of damage of the LV apparatus supplied by circuits in a multipolar cable is about a thousand times lower than the one relevant to circuits in plastic conduit. If the tolerable frequency of damage of the LV apparatus is kept in the range of 0.01 damage/year, the adoption of protection measures against overvoltages caused by the source S4 is practically not necessary, except for the case of long circuits in conduit, powered by long HV overhead lines in areas with high values of lightning flash density. As this matter has not yet been considered in the IEC 62305 standard series, the results presented in this paper will be useful in the light of the revision of requirements of this standard.