Since any error in the rotor angle caused by the resolver affects the entire PMSM control drive system, it is necessary to investigate its effect on mechanical vibrations. Torsional vibration is accordingly considered in the following study. Thereby, firstly, the effect of resolver errors on the harmonic content of motor current and subsequently Torque Ripple (TR) was investigated. Then, dynamical modeling is done for the generator-motor-resolver set to get the mechanical Frequency Response (FR) resulting from the resolver errors. Based on the above modeling, the Dynamic Equations (DEQ) of the system were derived, and the mechanical characteristics of the set, including natural frequency values and mode shapes, were extracted. Thereafter TR was employed in the DEQs, and the mechanical FR caused by the resolver error was obtained. Eventually, comparing mechanical FR with electrical FR was done according to diagnosis superiority. All analyzes were done using experimentally verified models.
One of the challenges in predicting the remaining useful life (RUL) of rolling element bearings (REBs) is determining a proper failure threshold (FT). In the literature, the FT is usually assumed to be a constant value of an extracted feature from the vibration signals. In this study, a degradation indicator was extracted to describe damage to REBs by applying principal component analysis (PCA) to their run-to-failure data. The relationship between this degradation indicator and the vibration peak was represented through a joint probability distribution using statistical copula models. The FT was proposed as a probability distribution based on the fluctuation increase in the vibration trend. A set of run-to-failure tests was conducted. Applying the proposed method to this dataset led to various FTs for the different failure modes that occurred. It is shown that, for inner race degradation, a higher FT can be assumed than for rolling element degradation. This could help extend the lives of REBs regarding the degrading elements. A dataset for an industrial machine was also analyzed and it is shown that the proposed model estimated a reasonable and proper FT in an actual case study.