This paper presents a computational fluid dynamics (CFD) study of vortex-induced vibration (VIV) for different aspect ratio (L/D) cylinder. Of particular interest was to measure hydrodynamic forces and numerically investigate the wake behaviour of VIV while varying the aspect ratio. The simulation models represented the actual experimental conditions with idealised free-surface boundary condition to capture the responses from fluid-structure interaction phenomenon. The simulations were performed in the subcritical flow region (7.4×10³ < Re < 2×10⁵), corresponding to a range of reduced velocity (U_r) from 2 to 14. The results of the cases studied were discussed and compared with the experimental data to verify the accuracy and validity of the present simulation. The comparisons have shown a similar curved-shape drag coefficient plot, and however underestimated the value of the drag coefficients over the reduced velocity. Additionally, the simulations seemed to capture a higher lift force response compared with the experimental data for a low aspect ratio. The correlation length was observed to be longer for larger aspect ratio and proportionally decreases as the aspect ratio decreases.

Overtopping breakwater for energy conversion (OBREC) is integration between breakwater and wave energy converter (WEC) that allows incoming waves to be stored in the reservoir. The higher the overtopping amount collected in a reservoir, the greater the energy generated will be. Hence, most of the overtopping concept has attempted to maximize the inclusion of water in the reservoir by optimizing geometrical parameters, particularly the ramp angle. However, the studies corresponding to ramp shapes geometries have not been adequately reviewed. Most studies only focused on the usage of linear overtopping ramp shape. There is still limited knowledge on the influence of different ramp shape parameters towards the overtopping wave. Thus, this paper aimed to push the border of available knowledge by investigating the influence of the ramp shape parameters to the overtopping wave discharge through simulation and experimenting approaches. Seven different ramp shapes have been tested under Malaysia’s wave condition and a new ramp shape parameter allowing for maximized overtopping wave on OBREC is presented.

For offshore structures, especially jacket supported structure such as fixed platform and offshore wind turbine, the underwater area provides an ideal site for corrosion formation and marine fouling. In this marine environment, the structures are exposed to particularly aggressive corrosion and colonized by marine organisms involving a diversity of species. In this paper, a number of cases are conducted where an existing fixed platform is subjected to uniform corrosion. Furthermore, the platform is also subjected to marine fouling. The platform is assessed to investigate the effects of corrosion and marine fouling on its structural strength by determining the Reserve Strength Ratio (RSR) value. It is found the platform is limited to at least 50 years of service life when subjected to average corrosion. However, the platform is no longer considered as safe after 37 years when subjected to severe corrosion. Moreover, there is an RSR loss of 38% when marine fouling is introduced at the first 5 years which is detrimental to the overall safety of the platform. On the other hand, there is minimum RSR loss of only 5% for most cases when marine fouling is introduced but still detrimental to the overall safety of the platform. The obtained outcomes were documented and will be useful information to conduct condition assessment (or structural health monitoring) of aged fixed jacket structures.

Floating structures, such as Spar platform, are likely to experience significant motions while operation due to Vortex-induced Motion (VIM). The main features of VIM include aspect ratio and mass ratio of the structure. This paper focuses on further development of a previously published semi-empirical method called wake oscillator model (WOM) for VIM, which aims to derive a mathematical correlation in modelling all features of the phenomenon. Analytical solution is proposed to coupled WOM and structure oscillator model based on the Van der Pol equation by integrating mass ratio, m* = 4.36, and various low aspect ratios between 0.3 and 2.0. Additionally, a new approach was initiated to embed several empirical parameters linked to the aspect ratio in the existing WOM. It was found the aspect ratio parameter in the modified WOM significantly affected the performance of the model for estimation of VIM on floating structures.