The aim of the study was to investigate the process of electrostatic fabrication of cellulose acetate (CA) nanofibers containing methylene blue (MB) as a photosensitizer. The electrical, physicochemical, and biocidal properties of the prepared material were given. CA nanofibers were prepared by electrospinning method using a solvent mixture of acetone and distilled water (9:1 vv−1) and different concentrations of CA (i.e., 10–21%). Additionally, methylene blue was implemented into the polymer solution with a CA concentration of 17% to obtain fibers with photo-bactericidal properties. Pure electrospun CA fibers were more uniform than fibers with MB (i.e., ribbon shape). Fiber diameters did not exceed 900 nm for the tested polymer solutions and flow rate below 1.0 mL h−1. The polymer properties (i.e., concentration, resistivity) and other parameters of the process (i.e., flow rate, an applied voltage) strongly influenced the size of the fibers. Plasma treatment of nanofibers resulted in reduced biofilm formation on their surface. The results of photo-bactericidal activity (i.e., up to 180 min) confirmed the high efficiency of inactivation of Staphylococcus aureus cells using fibers containing methylene blue (i.e., with and without plasma treatment). The most effective reduction in the number of biofilm cells was equal to 99.99 ± 0.3%.
Ferroelectret-based piezoelectric transducers are, nowadays, commonly used in energy harvesting applications due to their high piezoelectric activity. Unfortunately, the processing properties of such materials are limited, and new solutions are sought. This paper presents a new solution of a piezoelectric transducer containing electret bubbles immersed in an elastomer matrix. Application of a gas-filled dielectric bubble as the fundamental cell of the piezo-active structure is discussed. A simplified model of the structure, containing electret thin-wall bubbles and elastomer dielectric filling, was applied to determine the value of the piezoelectric coefficient, d33. An exemplary structure containing piezo-active bubbles, made of an electret material, immersed in an elastomer filling is presented. The influence of the mechanical and electrical properties of particular components on the structure piezoelectric properties are experimentally examined and confirmed. The quasi-static method was used to measure the piezoelectric coefficient, d33. The separation of requirements related to the mechanical and electrical properties of the transducer is discussed.
Piezo-electrical properties of structures containing ‘soft’ and ‘hard’ dielectric layers with charge stored on the interfaces are described in the paper. The piezo-activation process of structures containing layers with gas voids by partial discharges is described. The influence of the mechanical properties of the ‘soft’ layer on the piezoelectric parameter d33 value and its dependence on the static pressure p are also discussed. It was found experimentally, that for the fibrous type of ‘soft’ dielectric layer, the dependence of the piezoelectric parameter d33 (p) can be described by the function d33 ÷ p−n, where n ≤ 1.