Existing three-dimensional modeling approaches to single-screw extrusion can be classified according to the process sections. The discrete element method (DEM) allows describing solids transport in the feed section. The melt flow in the melt section can be calculated by means of computational fluid dynamics (CFD). However, the current state of the art only allows a separate consideration of the respective sections. A joint examination of the process sections still remains challenging. In this study, a novel modeling approach is presented, allowing a joint consideration of solids and melt transport and, beyond that, the formation of melt. For this purpose, the phase transition from the solid to liquid states is modeled for the first time within the framework CFDEMCoupling®, combining CFD and DEM by a novel melting model implemented in this study. In addition, a melting apparatus for the validation of the novel melting model is set up and put into operation. CFD-DEM simulations are carried out in order to calculate the melting rate and are compared to experimental results. A good agreement between the simulation and experimental results is found. From the findings, it can be assumed that the CFD-DEM simulation of single-screw extruder with a joint consideration of the feed and melt section is feasible.
With increasing computational capacities and advances in numerical methods, a simulation-based process and product design approach for spray dried products has become the focus of many researchers. In this context, a novel unresolved CFD-DEM simulation approach for single suspension droplets is presented, which models the drying and solidification process in a hot gas environment. The solidification process is described by the formation of bonds between the primary particles in the suspension droplet, showing a plausible solidification behavior, which starts when a critical solid concentration is reached at the droplet surface. The drying conditions for the single-droplet simulations are determined from a large-scale spray dryer simulation for different droplet size classes. The resulting solid particles from the CFD-DEM simulation show a higher tendency to form hollow particles at high drying rates when the locking point is reached at earlier stages of the drying process. Using these results, suitable operating conditions for the spray dryer can be determined, which favor the formation of particles with a targeted morphology.
Results of a flume experiment and numerical model of plastic accumulation in front of a plate are presented. The single phase CFD-DEM model formed a successful benchmark case to model plastic accumulation inside an ocean cleanup system. A fixed wooden plate was placed in a steady cross flow and plastic was released upstream of it. We recorded the evolution of the plastic accumulation profiles under slowly increasing plastic load. Experimental parameters were the flow velocity, draft of the plate (varying the plate Froude number) as well as three different types of plastic particles. The accumulation of oil in front of barriers and parallels to the phenomena of plastic accumulation were reviewed. As a second part of the project we used the open source CFD-DEM code CFDEM® to reproduce the flume experiment. It couples the discrete element method (DEM) software LIGGGHTS® and the open source computational fluid dynamics (CFD) software OpenFOAM®. A linear relationship of the relative depth of the accumulation with the Froude number of the plate was found for a given type of particle and reproduced in the numerical model. We identified limitations of the experimental setup, calibration experiments and the single phase CFD-DEM approach and outlined the steps for further research.