A precursor was prepared using a co-precipitation method to synthesize crystalline calcium tungstate. The prepared precursor was dried in an oven at 80 °C for 18 h. The dried powders, prepared without a heat treatment process, were observed in XRD analysis to be a crystalline CaWO4 phase, confirming that the synthesis of crystalline CaWO4 is possible even at low temperature. To use this crystalline CaWO4 as a light emitting material, rare earth ions were added when preparing the precursor. The CaWO4 powders doped with terbium (Tb3+) and europium (Eu3+) ions, respectively, were also observed to be crystalline in XRD analysis. The luminescence of the undoped CaWO4 sample exhibited a wide range of 300~600 nm and blue emission with a central peak of 420 nm. The Tb3+-doped sample showed green light emission at 488, 545, 585, and 620 nm, and the Eu3+-doped sample showed red light emission at 592, 614, 651, and 699 nm. Blue, green, and red CaWO4 powders with various luminescence properties were mixed with glass powder and heat-treated at 600 °C to fabricate a blue luminescent PiG disk. In addition, a flexible green and red light-emitting composite was prepared by mixing it with a silicone-based polymer. An anti-counterfeiting application was prepared by using the phosphor in an ink, which could not be identified with the naked eye but can be identified under UV light.
The precursor prepared by co-precipitation method was sintered at various temperatures to synthesize crystalline manganese tungstate (MnWO4). Sintered MnWO4 showed the best crystallinity at a sintering temperature of 800 °C. Rare earth ion (Dysprosium; Dy3+) was added when preparing the precursor to enhance the magnetic and luminescent properties of crystalline MnWO4 based on these sintering temperature conditions. As the amount of rare earth ions was changed, the magnetic and luminescent characteristics were enhanced; however, after 0.1 mol.%, the luminescent characteristics decreased due to the concentration quenching phenomenon. In addition, a composite was prepared by mixing MnWO4 powder, with enhanced magnetism and luminescence properties due to the addition of dysprosium, with epoxy. To one of the two prepared composites a magnetic field was applied to induce alignment of the MnWO4 particles. Aligned particles showed stronger luminescence than the composite sample prepared with unsorted particles. As a result of this, it was suggested that it can be used as phosphor and a photosensitizer by utilizing the magnetic and luminescent properties of the synthesized MnWO4 powder with the addition of rare earth ions.
Eu3+ doped and Eu3+, Yb3+ co-doped Gd3Ga5O12 phosphors have been developed by facile solid state reaction method which can be easily scaled-up in large quantity. The synthesis has been optimized to get a single phase material at 1300 °C. The phase and crystal parameters have been analyzed by using X-ray diffraction measurement. Photoluminescence excitation (monitored for the 5D0 → 7F1 transition of Eu3+) depicts that the active ion (Eu3+) can be excited through direct excitation into 4f band of Eu3+, through charge transfer band (Eu3+-O2−) excitation and also through the excitation into 8S7/2 → 6IJ intra f–f transition of Gd3+ ion, which significantly all together cover a broad excitation region in 200–420 nm. In addition, in the presence of Yb3+ ions, the emission is also achieved by near infrared excitation (976 nm), through a typical upconversion (UC) process. Thus, the material efficiently behaves as a dual mode emitting phosphor (emission is achieved both through normal fluorescence and through UC process). The conversion efficiency of silicon solar cells is only 15% of terrestrial solar energy for 200–400 nm region and also the sub-band gap energy (in infrared region) is lost as heat; therefore, this kind of dual mode phosphors may be used to overcome the above mentioned incomplete utilization of the solar spectrum and can open realm of new possibilities for energy harvesting.
1 January 2009 in Electrochemical and Solid-State Letters
-doped potassium niobate polycrystalline powder phosphors for , 0.03, 0.05, and 0.07 mol were prepared by the conventional solid-state reaction method and were characterized by X-ray diffraction (XRD), field-emission-scanning electron microscopy, transmission electron microscopy, and photoluminescence measurements. The XRD data have shown a single-phase orthorhombic structure for and 0.03 mol concentrations of ions, while an additional phase is observed at higher concentrations. The photoluminescence spectrum has shown an intense emission band at 1061 nm along with two weak emission bands at 881 and 1343 nm when the samples are excited with 514.5 nm radiation of an -ion laser. No drastic changes in the intensity of emissions are observed with concentration variation, except slight changes in the intensities and peak positions of crystal-field peaks.
23 April 2009 in Journal of Physics D: Applied Physics