Nanotechnology is used, to an increasing extent, in practically every aspect of the economy and society. One area where nanotechnology is constantly advancing is fire protection. Nanostructures are found in elements used in direct protection, such as in protective clothing, filters, and helmets. Solutions in the field of nanotechnology are also used in elements reducing the fire risk and increasing the fire safety, such as building materials and structures, paints, coatings, or fire safety equipment (e.g., fire detectors). However, new solutions may also pose a threat to the safety of people and the environment. As a result of operation or combustion and degradation processes, the emission of nano-substances with toxic properties may occur. Therefore, knowledge in this field is necessary, as it allows for the appropriate targeting and use of nanotechnology.

Electrical cables are a potential source of ignition and fire hazards in various types of buildings and industrial installations, as well as in all modes of transportation, including aircraft. Fires in buildings pose the greatest threat to human life and health. The composition of thermal degradation products depends mainly on the type of combustible materials and the type of combustion process—flaming or smoldering. The purpose of this paper was to determine, based on experimental studies, the effects of flaming and smoldering combustion on the response times of fire smoke detectors. In addition, the concentrations of fire gases formed in the process of duct combustion, including CO, SO₂, NO₂, NO, HCN, HCl, HBr and HF, were measured using an FTIR spectrometer. The results presented confirm the significant effect of the way the cable samples burned on detector tripping time. The highest concentration of smoke (Y) in the test chamber was obtained during flame combustion. It was further found that the characteristics of the cable insulation material used, such as the type of PVC, had a significant effect on the toxicity of the emitted gases. The largest amounts of toxic gases were emitted during the smoldering combustion of a cable with a plasticized PVC sheath.

Determining the appropriate position of a positive pressure ventilator, where it exhibits the highest efficiency (measured by the achieved volumetric flow rate), can influence the success of rescue operations conducted by fire protection units. The aim of this article is to evaluate the possibility of using LES (Large Eddy Simulation) analyses to verify the positioning parameters of positive pressure ventilators in numerical simulation conditions, without the need for time-consuming experiments. The article presents a comparative analysis of full-scale experimental studies (conducted on a test setup to assess the velocity profile of the air jet in open flow) and CFD numerical analyses. The analysis confirmed the convergence of the flow rate parameter entering the surface of the door opening model installed on the test setup. Depending on the distance of the ventilator position (1–7 m), a convergence degree ranging from 1.6% to 3.8% was achieved for the volumetric flow rate. This publication demonstrates that the LES model is a suitable tool for effectively determining the working positions of positive pressure ventilators, as defined in real working conditions (open flow). The analysis may serve as a helpful tool for manufacturers of mobile ventilators, who can use the method for the technological testing of their units without conducting time-consuming experiments.

Purpose: The aim of this publication is to present the results of theoretical research-evaluation of normative and legal documents used for the design and installation of voice alarm systems (VAS) in selected European countries. The aim of the research was to analyze and compare the functioning of voice alarm systems in Poland against the background of selected European countries. Introduction: Voice alarm systems are systems installed in buildings that enable the broadcast of warning signals and voice messages for the safety of people in the building. Mandatory use of voice alarm systems in selected buildings became applicable in Poland on January 16, 2006. In Europe, these systems have been present before. Over the years, there has been development of both the devices included in the systems, as well as the normative documents and legal acts that describe these systems. Methods: Within the research process, theoretical research was used, such as: analysis of literature and legal documents, synthesis, generalization, inference, comparison and analogy. As part of the research, documents from such countries as Poland, Great Britain (mainly England), Sweden, Norway, Germany and the Netherlands were analyzed. The selection of individual countries was guided by the level of development of these systems in a given country and the availability of source documents. Conclusions: The presented analysis of the requirements for the use of voice alarm systems shows how different the approach to the use of this type of systems is. Depending on individual experiences and the administrative structure of a given country, a variety of regulations, whether legal or normative (not always normative documents issued by state standardization institutions), can be seen in the field of voice alarm systems application. Unfortunately, one can get the impression that voice alarm systems are still not as popular as fire detection systems. The definition of the requirements for buildings in which the use of voice alarm systems should be obligatory and the requirements for the determination of the required level of speech intelligibility constitute the basis for the consistent development of this type of fire protection equipment. Such requirements should be specified either in legal regulations or in normative acts dedicated to voice alarm systems.