All independent second-order and third-order elastic constants in B95 aluminum alloy and B95/nanodiamond composite have been determined. To determine the second-order elastic constants, the densities and velocities of longitudinal and shear bulk acoustic waves in the materials under study have been measured. To quantitatively characterize the nonlinear elastic properties, the third-order elastic constants (TOECs) of B95 alloy and B95/nanodiamond composite have been determined. The Thurston-Brugger method has been used to experimentally determine the TOECs. For this purpose, the relative changes in the bulk wave velocity have been experimentally measured depending on the uniaxial compression applied to the samples under study and all independent TOECs have been calculated. The elastic wave velocities have been measured by the ultrasonic pulse method at a frequency of 10 MHz. The results obtained have been discussed.
New theoretical and experimental results of microwave acoustic wave propagation in diamond-based multilayer piezoelectric structures (MPS) as “Me1/(Al,Sc)N/Me2/(100) diamond/Me3” and “Me1/AlN/Me2/(100) diamond/Me3” under three metal film depositions, including the change in the quality factor Q as a result of Me3 impact, were obtained. Further development of our earlier studies was motivated by the necessity of creating a sensor model based on the above fifth layered MPS and its in-depth study using the finite element method (FEM). Experimental results on the change in operational checkpoint frequencies and quality factors under the effect of film deposition are in satisfactory accordance with FEM data. The relatively small decrease in the quality factor of diamond-based high overtone bulk acoustic resonator (HBAR) under the metal layer effect observed in a wide microwave band could be qualified as an important result. Changes in operational resonant frequencies vs. film thickness were found to have sufficient distinctions. This fact can be quite explained in terms of the difference between acoustic impedances of diamond and deposited metal films.
Measurements of the specific heat and elastic wave velocities for a C60 fullerene sample treated at high pressure and temperature are used to estimate the Debye temperature and the function ΔC=Cp−Cv,
Variations of the composition, structure, and mechanical properties (hardness, elastic modulus) of (Ti–Hf)N coatings with increasing Hf content (Ti : Hf ratio) are reported. As test samples,...