22 February 2021 in Applied Physics Letters
We have obtained an excitation of longitudinal bulk acoustic waves in a diamond-based High overtone Bulk Acoustic Resonator (HBAR) at microwave and enhanced frequency bands as EHF up to 40 GHz. As an effective piezoelectric transducer, an aluminum-scandium nitride film is employed. The frequency response of acoustic overtones excited in the HBARs with a different aperture in the 1.0 up to 40 GHz range is measured. Some peculiarities of HBAR's frequency response concerned with the thin film piezoelectric transducer are studied. It is established that the maximal magnitude of the quality factor varies near the value of about 10 000 within all the frequency bands investigated. The approximately frequency-independent Q-factor behavior can explain in terms the Landau–Rumer approximation describing the acoustic attenuation in a diamond. An estimation of the HBAR's quality parameter as Q × f ≈ 4 × 1014 Hz at 40 GHz is obtained. In our opinion, that value exceeds all known data among the given devices. The results obtained will be helpful in the development of microwave and EHF acoustic resonators as well as highly sensitive acoustic sensors. The development of the EHF band opens up the possibility of obtaining acoustic waves of submicrometer and nanometer scales (in various media) and implementing acoustic studies of micro- and nanoobjects.
15 March 2006 in Physica B: Condensed Matter
1 August 2017 in AIP Advances
A pressure-induced phase transition of multiwall carbon nanotubes (MWNT) to a new structure at room temperature is studied using a shear diamond anvil cell, X-ray photoelectron spectra (XPS), transmission electron microscope (TEM) and Raman procedures. We observe a cardinal pressure-induced change in the nanoparticles shape from multi-shell tubes to multi-shell spheres. MWNT transforms to onions with layers cross-linked by sp3 bonds under the 45-65 GPa compressive stress combined with shear deformation at room temperature. TEM and XPS results show that about 40% of the carbon atoms in the new phase are sp3-bounded.
22 July 2024 in Applied Physics Letters
Pure single crystal diamond is a superior material for electronic, quantum, and detection applications. The state-of-the-art level of background concentrations of boron and nitrogen in such diamonds is about 1 ppb, which is quite close to the detection limit of the best chemical analysis techniques. In this work, we show that the boron concentration of ∼0.1 ppb causes conductivity of ∼5 kΩ cm of the single crystal diamond if the nitrogen concentration is lower. In such a case, the temperature dependent Hall effect measurement provides ∼100 times better detection limit for the concentration of the impurities in diamond compared to the conventional optical techniques. As a result, we have found the background concentrations of boron and nitrogen at the level of 0.07 and 0.02 ppb, respectively. This fact leads to a conclusion that growth of the insulating diamond is possible only when the nitrogen concentration is higher than the boron concentration.
4 March 2024 in Applied Physics Letters
Synthetic nitrogen-doped diamond single crystals have various high-tech applications, but their electronic properties have not been sufficiently studied. In this research, we investigated temperature dependencies in the range T = (550–1143) K of the electrical resistivity and Hall mobility in synthetic single-crystal Ib-type diamonds doped with nitrogen during growth. A series of experimental samples were cut from diamond crystals grown by temperature gradient high-pressure high-temperature (TG-HPHT) and chemical vapor deposition (CVD) methods. They contain (0.085–6.5) × 1019 cm−3 single substitutional nitrogen atoms (C-centers) as measured by optical spectrometry methods. The Hall mobility of free electrons decreases from 600 to 150 cm2 V−1 s−1 in the CVD grown sample with the lowest N content and from 300 to 100 cm2 V−1 s−1 in highly doped HPHT grown samples in the temperature range of 550–900 K. At T = (900–1100) K, the mobility decreases to 50 cm2 V−1 s−1 in highly doped samples. The activation energies of electrical conductivity Ea and impurity-to-band energies of nitrogen donors ED decrease with increasing N concentration in the ranges (1.55–1.32) and (1.63–1.33) eV, respectively. The lowest compensation ratio k ∼ 1% in the moderately doped CVD diamond is unique for n-type diamonds. Typical values of k in highly N-doped crystals are in the range of 10%–20%, facilitating the use of N-doped diamonds in durable high-temperature electronic devices.
24 September 2020 in Physical Review B
The electronic band structure of the phosphorus-doped high-quality high-pressure and high-temperature–grown single crystal diamond was studied by infrared absorption, magneto- and electron paramagnetic resonance spectroscopy, and first-principles calculations. The complete picture of the and (, 3, 4) donor transitions with new and transitions allowed us to refine the energy levels of ground and exited states with those obtained from effective mass approximation calculation. For the first time, as far as we know, we have observed the fine doublet structures of the (((, and ( donor transitions with the splitting value of 1.05 meV. These doublet structures arise from the dynamic Jahn-Teller (JT) distortion which splits the energy level of the () state in the configuration into those of the () ground state and the (E) state in the configuration. The dynamic JT distortion of the tetrahedral donor ground state has been proved by following facts: the observation of vibronic energy levels and temperature behavior of doublet bands in the IR spectrum, the absence of P-donor-related electron paramagnetic resonance signals, and first-principles calculations. We believe that the dramatic broadening of the band attributed to the ( donor transition at 524 meV is caused by the resonant interaction of this 524 meV energy level with that of ∼517 meV formed due to the dynamic JT coupling of the (E) energy level equal to 387 meV with the longitudinal acoustic phonon of meV.