Benzophenone (BP) type UV filters are common environmental contaminants that are posing a growing health concern due to their increasing presence in water. Different studies have evidenced the presence of benzophenones (BP, BP-1, BP-2, BP-3, BP-4, BP-9, HPB) in several environmental matrices, indicating that conventional technologies of water treatment are not able to remove them. It has also been reported that these compounds could be associated with endocrine-disrupting activities, genotoxicity, and reproductive toxicity. This review focuses on the degradation kinetics and mechanisms of benzophenone-type UV filters and their degradation products (DPs) under UV and solar irradiation and in UV-based advanced oxidation processes (AOPs) such as UV/H₂O₂, UV/persulfate, and the Fenton process. The effects of various operating parameters, such as UV irradiation including initial concentrations of H₂O₂, persulfate, and Fe²⁺, on the degradation of tested benzophenones from aqueous matrices, and conditions that allow higher degradation rates to be achieved are presented. Application of nanoparticles such as TiO₂, PbO/TiO₂, and Sb₂O₃/TiO₂ for the photocatalytic degradation of benzophenone-type UV filters was included in this review.

Anti-aging cosmetics are often sought after in order to slow down the aging process. Free radicals are one of the main causes of skin aging, and therefore antioxidants are used in anti-aging cosmetics. The aim of this study was to investigate which method is the most suitable for determining the antioxidant capacity of these products. Having samples extracted, the antioxidant capacity of the extracts obtained was determined by the following spectrophotometric methods: DPPH, Folin-Ciocalteu, FRAP, the ABTS method and the ferroion chelation method with ferrosine. The antioxidant capacity of the samples varied depending on the extract type and the method used. DPPH and ferroion chelation measurements with ferrosine were carried out in the part of the spectrum where plant pigments absorb. These pigments are often found in anti-aging products affecting these methods measurement results. The Folin-Ciocalteu method is suitable for researching the antioxidant capacity of hydrophilic extracts, but not lipophilic ones, where turbidity and the formation of a gelled ring occur. The FRAP method revealed similar results for all the samples and proved to be less sensitive than the others. The ABTS method for both types of extracts has proven to be the most suitable and sensitive method for determining the antioxidant capacity of anti-aging products.

BACKGROUND: Computational research plays an important role in predicting the chemical and physical properties of biologically active compounds important in future structural modifications to improve or modify biological activity. OBJECTIVE: This research focuses on quantum chemical and spectroscopic investigations properties of synthesized 4-hydroxycoumarin derivatives. METHODS: Quantum chemical calculations were obtained using B3LYP, HF, and M06-2x level methods with the 6-31++G (d,p) basis set. Afterward, IR, 1H, 13C, UV-Visible experimentally parameters were compared with the results obtained using the B3LYP/6-31+G*(d) basis set of the molecules to be able to characterize the structures. RESULTS: Based on the quantum chemical calculations compound with acetamido group on the phenyl ring is the most reactive, and compound with nitro substituent is the least reactive and the the strongest electrophile among tested compounds. With the exception of compounds with dimethylamino group, all other compounds have a pronounced tautomer between OH and C = O group. The calculated and experimental values are in agreement with each other. CONCLUSION: The molecular structure in the ground state of six 3-cinnamoyl 4-hydroxycoumarin derivatives was optimized using density functional theory. The observed and computed values were compared and it can be concluded that the theoretical results were in good linear agreement with the experimental data.

Solvent and substitution effects on the UV/Vis spectroscopic and fluorescence behaviour of seven synthesized 3-substituted 4-hydroxycoumarin derivatives were tested. The tested compounds were dissolved in ethyl acetate, acetonitrile, and dimethyl sulfoxide. Absorption and emission spectra were recorded in the range of 200–800 nm. All tested 4-hydroxycoumarin derivatives showed good absorption in a wide range of 200–550 nm, depending on the properties of the substituents on the benzene ring of the cinnamoyl moiety and the type of solvent. In comparison to the unsubstituted analogue, compounds with an electron-donating group exhibited bathochromically shifted UV/Vis absorption and emission spectra. The highest fluorescence quantum yield was observed for compounds with dimethylamino and acetamido groups as substituents at the benzene ring. Considering that both substitution and solvent affect the absorption and emission spectra of the tested compounds, it can be concluded that judiciously selecting these parameters can improve their absorption and fluorescence properties, making them suitable for various analytical uses.